Microbial dustiness and particle release of different biofuels.

نویسندگان

  • A M Madsen
  • L Martensson
  • T Schneider
  • L Larsson
چکیده

Exposure to organic dust originating from biofuels can cause adverse health effects. In the present study we have assessed the dustiness in terms of microbial components and particles of various biofuels by using a rotating drum as a dust generator. Microbial components from straw, wood chips, wood pellets and wood briquettes were quantified by several methods. Excellent correlations (r >/= 0.85, P < 0.0001) were found: between lipopolysaccharide (LPS) (as determined by 3-hydroxy fatty acid analysis) and endotoxin (as determined by a Limulus test), cultivable bacteria, total number of bacteria and muramic acid; between endotoxin and cultivable bacteria, total number of bacteria and muramic acid; between total number of bacteria and muramic acid; between cultivable fungi and total number of fungi. Straw was dustier than the other biofuels in terms of actinomycetes, bacteria, muramic acid, endotoxin, LPS, particle mass and number of particles. One of the wood chips studied and the straws had comparatively high dustiness in terms of fungi, while both wood pellets and wood briquettes had comparatively low dustiness in terms of all microbial components. An initially high particle generation rate of straw and wood chips decreased over time whereas the particle generation rate of wood briquettes and wood pellets increased during a 5 min rotation period. Particles of non-microbial origin may be the determining factor for the health risk in handling briquettes and pellets. Straw dust contained significantly more microorganisms per particle than did wood chip dust, probably because bacteria were most abundant in straw dust. The concentrations of endotoxin and fungi were high in wood and straw dust; dust from one of the straws contained 3610 EU/mg and dust from one of the chips contained 7.3 x 10(6) fungal spores/mg. An exposure to 3 mg of straw or wood chips dust/m(3) (the Swedish and Danish OEL of unspecific inhalable dust) could cause exposures to endotoxin and fungi higher than levels were health symptoms are seen to develop. The very different levels of dustiness in terms of particles and microbial components of different biofuels shows that dustiness is an important health-relevant factor to consider when choosing among biofuels and when designing worksites for handling of biofuels.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

A novel device for measuring respirable dustiness using low-mass powder samples.

Respirable dustiness represents the tendency of a powder to generate respirable airborne dust during handling and therefore indicates the propensity for a powder to become an inhalation hazard. The dustiness of 14 powders, including 10 different nanopowders, was evaluated with the use of a novel low-mass dustiness tester designed to minimize the use of the test powder. The aerosol created from ...

متن کامل

Dustiness of Fine and Nanoscale Powders

Dustiness may be defined as the propensity of a powder to form airborne dust by a prescribed mechanical stimulus; dustiness testing is typically intended to replicate mechanisms of dust generation encountered in workplaces. A novel dustiness testing device, developed for pharmaceutical application, was evaluated in the dustiness investigation of 27 fine and nanoscale powders. The device efficie...

متن کامل

Combined single-drop and rotating drum dustiness test of fine to nanosize powders using a small drum.

A dustiness test has been developed that performs both a single-drop and a continuous rotation test using a 6-g sample. Tests were completed on pigment-grade and ultrafine TiO2, two grades of corundum (Aloxite), yttrium-stabilized zirconia (Y-zirconia) granules, fumed silica, goethite, talc and bentonite. The generated particles were quantified by counting and sizing at 1-s time resolution usin...

متن کامل

بررسی تأثیر اندازه ذره ای دارو و پلیمر HPMC K15M بر میزان رهش تئوفیلین از ماتریکس های پلیمری

Background and purpose: One of the methods of preparing controlled-release dosage forms is the incorporation of drug in a matrix containing a hydrophilic rate-controlling polymer. Drug-polymer ratio, drug particle size and HPMC particle size have been identified as modifiers of drug release. This study evaluated the relationship and influence of formulation factors such as drug-HPMC ratio and p...

متن کامل

Effect of Particle Size, Compaction Force and Presence of Aerosil 200 on the Properties of Matrices Prepared from Physical Mixture of Propranolol Hydrochloride and Eudragit RS or RL

Objective Eudragits are widely used polymers in the production of oral sustained release dosage forms. The application of these polymers in the production of inert insoluble matrices has been investigated. However the effect of particle size, compaction force and presence of Aerosil 200 as a glidant on the properties of Eudragit RS and RL matrices prepared by direct compression of their physic...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • The Annals of occupational hygiene

دوره 48 4  شماره 

صفحات  -

تاریخ انتشار 2004