MOS gas sensor technology for demand controlled ventilation
نویسندگان
چکیده
Due to increasing interest in indoor air quality and demand controlled ventilation in buildings aiming at energy and cost saving, as well as health and comfort aspects, the objective of our work has been the development of a reliable, low cost tool for demand ventilation control. Based on a single microelectromechanical (MEMS) metal oxide semiconductor (MOS) gas sensor VOC detection as close as possible to perceived air quality and additionally, a good correlation with measured CO2 concentrations due to implementation of an empirical data evaluation algorithm has been achieved.
منابع مشابه
Metal Decoration Effects on the Gas-Sensing Properties of 2D Hybrid-Structures on Flexible Substrates
We have investigated the effects of metal decoration on the gas-sensing properties of a device with two-dimensional (2D) molybdenum disulfide (MoS₂) flake channels and graphene electrodes. The 2D hybrid-structure device sensitively detected NO₂ gas molecules (>1.2 ppm) as well as NH₃ (>10 ppm). Metal nanoparticles (NPs) could tune the electronic properties of the 2D graphene/MoS₂ device, increa...
متن کاملEnergy saving potential and repercussions on indoor air quality of demand controlled residential ventilation strategies
Ventilation is ambiguously related to the energy saving rationale originating from the mitigation of global warming, the reaching of peak oil or health concerns related to fossil fuel burning. Since it makes up for about half of the energy consumption in well insulated buildings, it is an attractive target for energy saving measures. However, simply reducing ventilation rates has unwanted reper...
متن کاملFabrication of 1, 1-Dimethylhydrazine Gas sensor Based on Nano Structure Conducting Polyaniline
Determination of 1, 1-dimethylhydrazine (DMH) in air is carried out by spectrophotometry, GC or HPLC analysis, but in this study DMH was analyzed by a gas sensor based on nanostructure conducting polyaniline. Determination of DMH has been done very simplely and quickly in recent work. Electrically conductive fibers have been prepared by polymerization of aniline on surfaces of commercial polyme...
متن کاملThe Multi-Chamber Electronic Nose—An Improved Olfaction Sensor for Mobile Robotics
One of the major disadvantages of the use of Metal Oxide Semiconductor (MOS) technology as a transducer for electronic gas sensing devices (e-noses) is the long recovery period needed after each gas exposure. This severely restricts its usage in applications where the gas concentrations may change rapidly, as in mobile robotic olfaction, where allowing for sensor recovery forces the robot to mo...
متن کاملTiO2 based surface acoustic wave gas sensor with modified electrode dimensions for enhanced H2 sensing application
The design and optimization of nanostructure-based surface acoustic wave (SAW) gas sensor is analyzed based on TiO2 sensing layer and modified electrode dimensions. The sensitivity of the gas sensor depends upon the type of sensing layer used and active surface area obtained by varying the aspect ratio. The performance of the sensor is observed from 0.1ppm to 100ppm concentration of ...
متن کامل