Evaluation of the operating internal resistance, inductance, and capacitance of intact damped sine wave defibrillators.
نویسندگان
چکیده
A method is developed for determing actual values of circuit elements in a damped sine wave (Lown waveform) defibrillator solely from measurements of the output, using two or more power resistors and a storage oscilloscope. If a defibrillator containing capacitance C, inductance L, and internal resistance RI, is discharged into increasing 5- to 100-ohm resistive loads R, it is shown for underdamped output waveforms that â = RI/2L + R/2L and ĉ = CRI + CR, where â = pi[t2tan(pit1/t2)], ĉ = 2â/[â2 + (pi/t2)2], t1 = time from onset to peak, and t2 = time from onset to first zero crossing of the output waveform on the oscilloscope trace. Linear plots of â vs R are constructed for seven defibrillators, and values of RI and L computed as intercept/slope and 1/(2 slope) respectively. C is given by the slope of a linear plot of ĉ vs R. Delivered energy is accurately predicted as stored energy X R/(RI + R).
منابع مشابه
Evaluation of the operating internal resistance and capacitance of intact trapezoidal waveform defibrillators.
متن کامل
Multicenter comparison of truncated biphasic shocks and standard damped sine wave monophasic shocks for transthoracic ventricular defibrillation. Transthoracic Investigators.
BACKGROUND The most important factor for improving out-of-hospital ventricular fibrillation survival rates is early defibrillation. This can be achieved if small, lightweight, inexpensive automatic external defibrillators are widely disseminated. Because automatic external defibrillator size and cost are directly affected by defibrillation waveform shape and because of the favorable experience ...
متن کاملTransmission Line Parameters
Universidad Autónoma de Zacatecas 13.1 Equivalent Circuit ........................................................... 13-1 13.2 Resistance ......................................................................... 13-2 Frequency Effect . Temperature Effect . Spiraling and Bundle Conductor Effect 13.3 Current-Carrying Capacity (Ampacity) ........................ 13-5 13.4 Inductance and Inductive...
متن کاملCompact Lossy Inductance Simulators With Electronic Control
In this paper two R‑L network simulator configurations employing a single VDDIBA, one resistance and one grounded capacitance are presented. The first configuration is a grounded series resistor-inductor (R‑L) network simulator and the second configuration is intended for grounded parallel resister-inductor (R‑L) circuit simulation. Both the proposed circuits enjoy several beneficial features s...
متن کاملReducing the inductance requirements of piezoelectric shunt damping systems
Structural vibration can be reduced by shunting an attached piezoelectric transducer (PZT) with an electrical impedance. Current shunt circuit designs, e.g. a single-mode inductor–resistor network, typically require large inductance values of up to thousands of henries. In practice, discrete inductors are limited in size to around 1 H. By placing an additional capacitance across the terminals o...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- Medical instrumentation
دوره 12 1 شماره
صفحات -
تاریخ انتشار 1978