The resistive wall mode and feedback control physics design in NSTX

One of the goals of the National Spherical Torus Experiment (NSTX) is to investigate the physics of global mode stabilization in a low aspect ratio device. NSTX has a major radius R0 = 0.86 m, a midplane half-width of 0.7 m, and an on-axis vacuum toroidal field B0 0.6 T and has reached a plasma current Ip = 1.5 MA. Experiments have established the wall-stabilized MHD operating space of the machine. The maximum βt and βN have reached 35% and 6.5%, respectively, with βN reaching 9.5li. Collapses in plasma toroidal rotation and βt have been correlated with violation of the n = 1 ideal MHD beta limit, βN no-wall, computed by the DCON stability code using timeevolving EFIT reconstructions of experimental discharges. The resistive wall mode (RWM) was observed over a wide range of βN when βN no-wall was exceeded. Plasma toroidal rotation damping during the RWM was rapid and global. Damping rates were more than five times larger than caused by low toroidal mode number rotating modes alone, which displayed a slower, diffusive rotation damping away from the rational surface. The rotation damping rate and dynamics depend on the applied toroidal field and the computed minimum value of the safety factor. The computed RWM perturbed field structure from experimental plasma reconstructions has been input to the VALEN feedback analysis code for quantitative comparison of experimental and theoretical RWM growth rates and to analyse the effectiveness of various active feedback stabilization designs. The computed RWM n = 1 mode growth rate, which depends on plasma equilibrium parameters such as βN and pressure profile peaking, agrees well with experimental growth rates in different operating regimes. Increasing βN in the ST initially improves mode coupling to the stabilizing wall; however, at the highest βN values reached, the ideal with-wall beta limit, βN wall, is approached, the effectiveness of the passive stabilizing plates is reduced, and the computed RWM growth rate approaches ideal MHD growth rates. Several active mode control designs were considered and evaluated. The most effective configuration is computed to provide stabilization at βN up to 94% of the ideal with-wall limit. PACS numbers: 52.55.Fa, 52.55.Tn, 52.65.Kj, 52.35.Py (Some figures in this article are in colour only in the electronic version)