Gas-phase Diffusive Tracer Test for the In-Situ Measurement of Tortuosity in the Vadose Zone
نویسندگان
چکیده
Robust measurements of porous-medium tortuosity are one of the many components needed for accurate characterization and prediction of fluid flow and contaminant transport in the subsurface. A gasphase diffusive tracer-test method is evaluated for the in-situ measurement of tortuosity in the vadose zone. This technique presents an alternative to employing widely-used correlations to estimate tortuosity. A small-scale field study was conducted using a single well and a non-reactive gas-phase tracer (sulfur hexafluoride; SF6). Gas samples were collected from the injection point periodically after tracer injection into the soil matrix. An effective radius of influence of 50 cm was determined for the tests. An analytical solution was calibrated to the measured temporal concentration distribution, producing a fitted value for tortuosity. The value obtained from the tracer tests was compared to values estimated with several widely-used correlations. The value obtained from the tracer tests was generally larger than the values estimated with the correlations, which spanned a relatively wide range. The tracer-test method provides a means by which to determine in-situ measurements of tortuosity, allowing for better characterization of contaminant transport in the vadose zone.
منابع مشابه
Risk assessment of industrial hydrocarbon release and transport in the vadose zone as it travels to groundwater table: A case study
In this paper, a modeling tool for risk assessment analysis of the movement of hydrocarbon contaminants in the vadose zone and mass flux of contamination release into the groundwater table was developed. Also, advection-diffusion-reaction equations in combination with a three-phase equilibrium state between trapped air, soil humidity, and solid particles of unsaturated soil matrix were numerica...
متن کاملارزیابی عملکرد هودهای آزمایشگاهی براساس استاندارد ASHRAE 110 در
Background and Aim: Laboratory fume-hoods are the first-level protection for the laboratory staff against hazardous chemical pollutants. Considering the large numbers of personnel, especially in petrochemical industry laboratories, this project was carried out in order to assess the performance of laboratory hoods based on tracer gas (SF6).Materials and Methods: In this project 22 hoods in the ...
متن کاملStochastic reconstruction of carbon fiber paper gas diffusion layers of PEFCs: A comparative study
A 3D microstructure of the non-woven gas diffusion layers (GDLs) of polymer electrolyte fuel cells (PEFCs) is reconstructed using a stochastic method. For a commercial GDL, due to the planar orientation of the fibers in the GDL, 2D SEM image of the GDL surface is used to estimate the orientation of the carbon fibers in the domain. Two more microstructures with different fiber orientations are g...
متن کاملThe Effect of Barometric Pumping on Field Determined Respiration Rate for Bioventing Process
Field measured respiration rates are necessary to size the appropriate oxygen supply equipment and to determine the proper injection/extraction flow rate and operating mode in the design of a bioventing system. Respiration rates are also used to estimate the amount of contaminant metabolized during the bioventing process. Almost all respiration tests are conducted in an open system subject to a...
متن کاملNumerical modeling of three-phase flow through a Venturi meter using the LSSVM algorithm
One of the challenging problems in the Oil & Gas industry is accurate and reliable multiphase flow rate measurement in a three-phase flow. Application of methods with minimized uncertainty is required in the industry. Previous developed correlations for two-phase flow are complex and not capable of three-phase flow. Hence phase behavior identification in different conditions to designing and mo...
متن کامل