Degradation of Li/S Battery Electrodes On 3D Current Collectors Studied Using X-ray Phase Contrast Tomography
نویسندگان
چکیده
Lithium/sulphur batteries are promising candidates for future energy storage systems, mainly due to their high potential capacity. However low sulphur utilization and capacity fading hinder practical realizations. In order to improve understanding of the system, we investigate Li/S electrode morphology changes for different ageing steps, using X-ray phase contrast tomography. Thereby we find a strong decrease of sulphur loading after the first cycle, and a constant loading of about 15% of the initial loading afterwards. While cycling, the mean sulphur particle diameters decrease in a qualitatively similar fashion as the discharge capacity fades. The particles spread, migrate into the current collector and accumulate in the upper part again. Simultaneously sulphur particles lose contact area with the conducting network but regain it after ten cycles because their decreasing size results in higher surface areas. Since the capacity still decreases, this regain could be associated with effects such as surface area passivation and increasing charge transfer resistance.
منابع مشابه
Exploring 3D microstructural evolution in Li-Sulfur battery electrodes using in-situ X-ray tomography
Lithium sulfur (Li-S) batteries offer higher theoretical specific capacity, lower cost and enhanced safety compared to current Li-ion battery technology. However, the multiple reactions and phase changes in the sulfur conversion cathode result in highly complex phenomena that significantly impact cycling life. For the first time to the authors' knowledge, a multi-scale 3D in-situ tomography app...
متن کاملElectrocatalysis of Lithium Polysulfides: Current Collectors as Electrodes in Li/S Battery Configuration
Lithium Sulfur (Li/S) chemistries are amongst the most promising next-generation battery technologies due to their high theoretical energy density. However, the detrimental effects of their intermediate byproducts, polysulfides (PS), have to be resolved to realize these theoretical performance limits. Confined approaches on using porous carbons to entrap PS have yielded limited success. In this...
متن کاملComputational Methods for Nanoscale X-ray Computed Tomography Image Analysis of Fuel Cell and Battery Materials
Over the last fifteen years, there has been a rapid growth in the use of high resolution X-raycomputed tomography (HRXCT) imaging in material science applications. We use it atnanoscale resolutions up to 50 nm (nano-CT) for key research problems in large scale operationof polymer electrolyte membrane fuel cells (PEMFC) and lithium-ion (Li-ion) batteries inautomotive applications...
متن کاملInvestigation of cycling-induced microstructural degradation in silicon-based electrodes in lithium-ion batteries using X-ray nanotomography
The microstructural degradation of a composite silicon electrode at different stages in its cycle life was investigated in 3D using X-ray nano-computed tomography. A reconstructed volume of 36 mm 27 mm 26 mm from the composite electrode was imaged in its pristine state and after 1, 10 and 100 cycles. Particle fracturing and phase transformation was observed within the electrode with increased c...
متن کاملAdvanced materials for the 3D microbattery
Out recent achievements in the development of three-dimensional (3D) thin film microbatteries on silicon and on microchannel plates (MCP) are presented. In such 3D microbatteries, the battery sandwich-like structure, including electrodes, electrolyte and current collectors, is deposited conformally on all available surfaces, thereby utilizing the dead volume of the substrate. Thin-film molybden...
متن کامل