Thermal conductivity and thermodynamics of majoritic garnets: implications for the transition zone

نویسنده

  • P. A. Giesting
چکیده

Thermal conductivity at room temperature and pressure (k0), and heat capacity and total entropy as functions of temperature are calculated for majorite^pyrope garnets from new and previous infrared reflectivity and Raman scattering data. The thermodynamic properties, including the effect of cation disorder, vary by less than 4% over this binary, whereas k0 changes by s 400% due to cation disorder. For mantle garnet compositions (V70 mol% majorite), k0 is V2.3 W/m K, which is V25% k0 of ringwoodite, the other major mineral in Earth’s transition zone (TZ). The dynamics of the TZ is governed by its two dominant minerals having disparate values for k and viscosity, which parallels the situation in the lower mantle. If the TZ has substantial (60^70%) proportions of majoritic garnet, as suggested by petrological models, then heat flow therein is inhibited relative to the upper and lower mantles. Subadiabatic temperatures are implied, which is consistent with steep velocity gradients in the TZ. Association of low thermal conductivity with high temperatures should contribute to the buoyancy of the TZ layer, weaken it, and promote transformation to garnet: such destablization through positive feedback possibly provides a mechanism for catastrophic overturns of the TZ and upper mantle. ? 2003 Elsevier B.V. All rights reserved.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Crystal structure and Raman spectrum of a high-pressure Li-rich majoritic garnet, (Li2Mg)Si2(SiO4)3

A Li-rich majoritic garnet (LiMGt), (Li2Mg)Si2(SiO4)3, was synthesized at 15 GPa and 1500 °C and its structure studied with single-crystal X-ray diffraction and Raman spectroscopy. It is cubic with space group Ia3d and unit-cell parameters a = 11.2660(2) Å and V = 1429.91(1) Å3. The 8-, 6-, and 4-coordinated cation sites in LiMGt are occupied by (Li+ + Mg2+), Si4+, and Si4+, respectively. Where...

متن کامل

Geothermal Potential Assesment of Way Ratai Area Based on Thermal Conductivity Measurement to Measure Thermal Properties of Rocks

Thermal conductivity measurements have been used for the Way Ratai geothermal prospect area. The thermal conductivity method is used to evaluate the ability of a rock to deliver heat by conduction. In the area, many surface manifestations are scattered in various regions, where hot springs dominate these various manifestations. The thermal conductivity mapping of rocks is carried out around geo...

متن کامل

Microstructure and Mechanical Properties of the Friction Welded Joint between X53CrMnNiN219 and X45CrSi93 Stainless Steel

Dissimilar metals friction welding of austenitic–martensitic stainless steels is commonly used in order to manufacture engine valves in the automobile industry. In this study, X53CrMnNiN219 (austenitic stainless steel) and X45CrSi93 (martensitic stainless steel) valve steel rods were welded by friction welding process. The welded joint was then heat treated at 760 0C for 60 min. Mechanical prop...

متن کامل

Relaxation and Thermal Conductivity of Hot and Thermal Quasiparticles and Fermi Liquid Interactions in d-wave Superconductors

In this paper, we calculate theoretically the relaxation rates of hot, thermal and antinodal quasiparticles by using Fermi’s golden rule. The transition probabilities at low temperatures express in terms of Bogoliubov coefficients, singlet and triplet scattering amplitudes and dimensionless Landau parameters. The values of Landau parameters may be determined by comparison with the experimental ...

متن کامل

Experimental evaluation of thermal stability of PS- MWCNT nanocomposite as a real-time dosimeter

Introduction: Carbon nanotubes (CNTs) are ideal reinforcing fillers for a polymer matrix, because of their nanometer size, high aspect ratio and, more importantly, their excellent mechanical strength, and electrical and thermal conductivity. The CNTs are categorized into two groups: SWCNT and MWCNT. MWCNTs would have diameters ranging from 2 to 100 nm and lengths of up to tens ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2004