Numerical Simulations of the Formation of Hurricane

نویسندگان

  • Gabrielle
  • K. D. MUSGRAVE
  • C. A. DAVIS
  • M. T. MONTGOMERY
چکیده

This study examines the formation of Hurricane Gabrielle (2001), focusing on whether an initial disturbance and vertical wind shear were favorable for development. This examination is performed by running numerical experiments using the fifth-generation Pennsylvania State University–National Center for Atmospheric Research Mesoscale Model (MM5). Gabrielle is chosen as an interesting case to study since it formed in the subtropics only a few days before making landfall in Florida. Three simulations are run: a control run and two sensitivity experiments. The control run is compared with observations to establish the closeness of the model output to Gabrielle’s observed formation. The two sensitivity experiments are designed to test the response of the developing tropical cyclone to alterations in the initial conditions. The first sensitivity experiment removes the initial (or precursor) disturbance, a midtropospheric vortex located over Florida. The second sensitivity experiment reduces the vertical wind shear over the area of formation. The control run produces a system comparable to Gabrielle. The convection in the control run is consistently located downshear of the center of circulation. In the first sensitivity experiment, with the removal of the initial disturbance, no organized system develops. This indicates the importance of the midtropospheric vortex in Gabrielle’s formation. The second sensitivity experiment, which reduces the vertical wind shear over the area of Gabrielle’s formation, produces a system that can be identified as Gabrielle. This system, however, is weaker than both the control run and the observations of Gabrielle. This study provides direct evidence of a favorable influence of modest vertical wind shear on the formation of a tropical cyclone in this case.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

NOTES AND CORRESPONDENCE Impact of the Reduced Drag Coefficient on Ocean Wave Modeling under Hurricane Conditions

Effects of new drag coefficient (Cd) parameterizations on WAVEWATCH III (WW3) model surface wave simulations are investigated. The new parameterizations are based on a coupled wind–wave model (CWW) and a wave tank experiment, and yields reduced Cd at high wind speeds. Numerical experiments for uniform winds and Hurricane Katrina (2005) indicate that the original Cd parameterization used in WW3 ...

متن کامل

Numerical Analysis of Water and Air in Venturi Tube to Produce Micro-Bubbles

Two-phase flow regimes are affected by conduit position, alignment, geometry, flow direction, physical characteristics, and flow rate of each phase as well as the heat flux toward the boundaries. Due to the importance of two-phase flow, numerous regimes have been identified. The first step in studying micro-bubble formation inside a venturi tube is to recognize the type of flow regimes. In this...

متن کامل

Water Flooding Performance Evaluation Using Percolation Theory

Water flooding is a well-known secondary mechanism for improving oil recovery. Conventional approach to evaluate the performance of a water flooding process (e.g. breakthrough and post breakthrough behavior) is to establish a reliable geological reservoir model, upscale it, and then perform flow simulations. To evaluate the uncertainty in the breakthrough time or post breakthrough behavior, thi...

متن کامل

Experimental and Numerical Investigation of Microstructural Evolutions, Mechanical Properties and Fracture Mode of AISI 1075 Resistance Weld

Weldability of high carbon steels due to the high percentage of carbon and consequently formation of martensitic structure is very poor. In this research, resistance spot welding of eutectoid high carbon steel 1075 is experimentally and numerically investigated from various points of view. The effect of welding current as one of the most effective parameters on failure mode, mechanical properti...

متن کامل

Experimental and Numerical Investigation of Microstructural Evolutions, Mechanical Properties and Fracture Mode of AISI 1075 Resistance Weld

Weldability of high carbon steels due to the high percentage of carbon and consequently formation of martensitic structure is very poor. In this research, resistance spot welding of eutectoid high carbon steel 1075 is experimentally and numerically investigated from various points of view. The effect of welding current as one of the most effective parameters on failure mode, mechanical properti...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2012