A Precise Visual Method for Narrow Butt Detection in Specular Reflection Workpiece Welding
نویسندگان
چکیده
During the complex path workpiece welding, it is important to keep the welding torch aligned with the groove center using a visual seam detection method, so that the deviation between the torch and the groove can be corrected automatically. However, when detecting the narrow butt of a specular reflection workpiece, the existing methods may fail because of the extremely small groove width and the poor imaging quality. This paper proposes a novel detection method to solve these issues. We design a uniform surface light source to get high signal-to-noise ratio images against the specular reflection effect, and a double-line laser light source is used to obtain the workpiece surface equation relative to the torch. Two light sources are switched on alternately and the camera is synchronized to capture images when each light is on; then the position and pose between the torch and the groove can be obtained nearly at the same time. Experimental results show that our method can detect the groove effectively and efficiently during the welding process. The image resolution is 12.5 μm and the processing time is less than 10 ms per frame. This indicates our method can be applied to real-time narrow butt detection during high-speed welding process.
منابع مشابه
A Vision-Aided 3D Path Teaching Method before Narrow Butt Joint Welding
For better welding quality, accurate path teaching for actuators must be achieved before welding. Due to machining errors, assembly errors, deformations, etc., the actual groove position may be different from the predetermined path. Therefore, it is significant to recognize the actual groove position using machine vision methods and perform an accurate path teaching process. However, during the...
متن کاملVisual Tracking System for the Welding of Narrow Butt Seams in Container Manufacture
In this paper, a vision based seam tracking system is proposed for the butt welding in the container manufacture. First, the system structure is designed. Then, the main parts of the system are discussed. The system’s working principle is analyzed. And the algorithms especially the image processing algorithm and control algorithm are proposed. Finally, experiments are conducted to demonstrate t...
متن کاملKeyhole Double-sided Arc Welding Process for Deep Narrow Penetration
In regular arc welding, the arc heat is transferred from the surface of the workpiece to melt it. In keyhole plasma arc welding, the workpiece is melted by the plasma jet which heats the wall of the keyhole along the thickness direction. Penetration is achieved with reduced heat input. However, the plasma jet only gains its energy in the arc before reaching the keyhole. In the keyhole where no ...
متن کاملLaser Welding of Aluminium Alloy 5083
There are two laser welding mechanisms, keyhole mode and conduction mode. Keyhole welding is widely used because it produces welds with high aspect ratios and narrow heat affected zones. However keyhole welding can be unstable, as the keyhole oscillates and closes intermittently. This intermittent closure causes porosity due to gas entrapment. Conduction welding, on the other hand, is more stab...
متن کاملVisual Sensing Systems for Arc Welding Process
Visual sensing technology is widely used in welding practices because visual devices are decreasing in price, increasing in reliability and improving in image processing hardware and software. As the most studied welding sensor, CCD(Charge Coupled Device) is more suitable for quality control of welding process than other means of sensing devices because it can obtain both two dimensional and th...
متن کامل