Simulation and Analysis of Multiple Converter Using Matrix Topology
نویسندگان
چکیده
This paper presents novel concept of a multiple converter. It works in three modesAC-AC converter voltage regulator, AC-AC converter frequency changer and AC-DC converter. All three modes work simultaneously. AC-AC converter mode of operation alters low input frequency to high output frequency across the load. AC-DC converter mode of operates with variable amplitude across load. This concept is implemented for a single phase supply using MATRIX topology. The control signals for the power switches are generated in a very clear form. The Simulation of the Converter is carried out in MATLAB/SIMULINK and results are presented for both modes of operation with low frequency and high frequency operation for AC-AC Mode and Variable voltage for AC-DC conversion mode.This paper discusses the proposed new multiple converter for single phase input using matrix topology for AC-AC conversion and ACDC conversion using just a single control logic..
منابع مشابه
Design and Simulation of a New DC Power Supply Based on Dual Bridge Matrix Converter
A conventional high power DC power supply systems consist of a three-phase diode rectifier followed by a high frequency converter to supply loads at regulated DC voltage. These rectifiers draw significant harmonic currents from the utility, resulting in poor input power factor. In this paper, a DC power supply based on dual-bridge matrix converter (DBMC) with reduced number of switches is p...
متن کاملThree-Phase to Single-Phase Matrix Converters: New Topology Based on New Control Method
In this paper, a new topology is proposed for three-phase to single-phase matrix converters, where more voltage levels are produced in the output in comparison with the conventional topologies. In addition, a new control method based on minimum error between the generated and the desired output voltages is proposed for three-phase to single-phase matrix converters. In the proposed control metho...
متن کاملA Robust STATCOM Controller using Particle Swarm Optimization
In this paper, a statcom without any energy storage devices is proposed to compensate network voltage during disturbances. This statcom utilizes a matrix converter in its topology which eliminates the DC-link capacitor of conventional statcom. The modulation method for matrix converter which is used in this paper is space vector modulation. There are some methods to improve power quality for se...
متن کاملCascaded Multilevel Inverter Based on Quasi-Z-Source Converter: Analysis, Design and Study of Optimal Structures
In this paper, a new topology for cascaded multilevel inverter based on quasi-Z-source converter is proposed. In the proposed topology the magnitude of output DC voltage is not limited to the sum of magnitude of DC voltage sources. Moreover, the reliability of the circuit due to capability of short circuit by Z-source network is increased. The quasi-Z- source converter in different modes is ana...
متن کاملA Soft Switched DC-DC Boost Converter for Use in Grid Connected Inverters
This paper presents a soft-switching DC-DC boost converter, which can be utilized in renewable energy systems such as photovoltaic array, and wind turbine connections to infinite bus of a big power network, using grid connected inverters. In the proposed topology for the DC-DC boost converter, the main and the auxiliary power switches are turned on and turned off with zero voltage switching (ZV...
متن کامل