Spectroscopic Investigation of Composite Polymeric and Monocrystalline Systems with Ionic Conductivity
نویسندگان
چکیده
The conductivity mechanism is studied in the LiCF3SO3-doped polyethylene oxide by monitoring the vibrations of sulfate groups and mobility of Li + ion along the polymeric chain at different EO/Li molar ratios in the temperature range from 16 to 90 °С. At the high EO/Li ratio (i.e., 30), the intensity of bands increases and a triplet appears at 1,045 cm −1 , indicating the presence of free anions, ionic pairs and aggregates. The existence of free ions in the polymeric electrolyte is also proven by the red shift of bands in Raman spectra and a band shift to the low frequency Infra-red region at 65 < T < 355 °С. Based on quantum mechanical modeling, (method MNDO/d), the energies (minimum and maximum) correspond to the most probable and stable positions of Li + along the polymeric chain. At room temperature, Li + ion overcomes the intermediate state (minimum energy) through non-operating transitions (maximum energy) due to permanent intrapolymeric rotations (rotation of C, H and O atoms around each other). In solid electrolyte (Li2SO4) the mobility of Li + ions increases in the temperature range from 20 to 227 °С, yielding higher conductivity. The results of the present work can be practically applied to a wide range of compact electronic devices, which are based on polymeric or solid electrolytes.
منابع مشابه
AN FT-IR SPECTROSCOPIC INVESTIGATION OF IONIC SOLVATION OF ALKALINE EARTH CATIONS WITH DIMETWYLSULFOXIDE IN ANHYDROUS ACETONITRILE
The interaction between DMSO and alkaline earth perchlorates in anhydrous acetonitrile was investigated by FT-IR spectroscopy. A quantitative study was performed to determine the average number of bonded DMSO molecules using v (SO) and v (C-S) vibrations. Changes in coordination numbers were observed both with increasing atomic numbers and the solvent composition. None of the investigated...
متن کاملSTRUCTURAL AND IONIC CONDUCTIVITYSTUDIES ONPLASTICIZED PAN-SODIUM FLUORIDE POLYMER ELECTROLYTES FOR ELECTROCHEMICAL CELL APPLICATIONS
Ion conducting gel polymer electrolytes based on poly acrylonitrle (PAN) complexed with different weight percent ratios of Sodium Fluoride (NaF) salt were prepared by using solution cast technique. Structural characterization was performed using X-ray diffraction (XRD) technique and Fourier transforms infrared (FTIR) spectroscope technique. From the X-rd results increase in amorphous phase with...
متن کاملPolymeric composite membranes for temperature and pH-responsive delivery of doxorubicin hydrochloride
Objective(s): Nowadays hydrogels are one of the upcoming classes of polymer-based controlled-release drug delivery systems. Temperature and pH-responsive delivery systems have drawn much attention because some diseases reveal themselves by a change in temperature and/or pH. The objective of this work is to prepare and characterize composite membrane using responsive nanoparticles into a polymer...
متن کاملPreparation and Physical Characterization of Sulfonated Poly (Ether Ether Ketone) and Polypyrrole Composite Membrane
Sulfoanted poly(ether ether ketone) membranes were prepared by the sulfonating agent sulfuric acid. These membranes were modifed by incorporating conducting polymer polypyrrole in order to increase the ionic conductivity and reduce the methanol transmission rate. The modifed composite membranes were then compared on the basis of ionic conductivity, methanol transmission...
متن کاملFunctionalized and Electrospun Polymeric Materials as High-Performance Membranes for Direct Methanol Fuel Cell: A Review
Proton exchange membranes (PEM) for a direct methanol fuel cell (DMFC) have main drawbacks which are methanol permeability, reduced proton conductivity and the cost of the membrane. This paper reviews different polymeric materials such as fluorinated, non-fluorinated, acid-base complex, and composite membranes for DMFC. Currently, nonfluorinated membranes gain a lot of atte...
متن کامل