A method of serial data jitter analysis using one-shot time interval measurements
نویسنده
چکیده
A method for measuring inter-sym cycle distortion, random jitter a described. The Blackman-Tukey method of s This allows the application of jitt ensure compliance to data communic Note: Mathematical analysis and have been performed. The autocorre FFT for clock jitter analysis have be current product. A provisional paten filed.
منابع مشابه
Modeling of Jitter Characteristics for the Second Order Bang-Bang CDR
Bang-Bang clock and data recovery (BBCDR) circuits are hard nonlinear systems due to the nonlinearity introduced by the binary phase detector (BPD). The specification of the CDR frequency response is determined by jitter tolerance and jitter transfer. In this paper, jitter transfer and jitter tolerance of the second-order BBCDR are characterized by formulating the time domain waveforms. As a re...
متن کاملDesignCon 2007
Oscilloscopes have been used extensively to analyze the jitter performance of serial data links providing estimates (measurements) of total jitter as well as its “random” and “deterministic” parts. Higher speed serial data signals containing jitter from sources such as crosstalk and multi-Gaussian random noise can cause traditional oscilloscope-based methods to greatly over or under estimate th...
متن کاملThe Accuracy of Jitter Measurements
Jitter is a variation in a waveform’s timing. The timing variation of the period, duty cycle, frequency, etc. can be measured and compared to an average of multiple periods, or can be measured as a variation from one period to the next. A jitter measurement result will typically consist of a count of the number of periods evaluated over the selected time interval, a measurement of the highest v...
متن کاملJitter Measurements in Serial Data Signals
Introduction The increasing speed of serial data transmission systems places greater importance on measuring jitter with higher accuracy. Serial data standards normally require operation at an expected error rate of 10. While this represents only one bit error every 2.3 hours at 100 Mb/s, it translates to one error every 4 minutes at 3Gb/s. It is, therefore, important to understand the characte...
متن کاملAnalysis of PLL Clock Jitter in High-Speed Serial Links
We analyze the effects of transmitter and receiver phased-locked loop (PLL) phase noise, which translates to time-domain clock/data jitter, on the performance of high-speed transceivers. Analytical expressions are derived to incorporate both transmitter and receiver clock jitter into serial link operation. A method to calculate the worst-case noise margin degradation due to clock jitter is disc...
متن کامل