Strip Blowing from a Wedge at Hypersonic Speeds
نویسنده
چکیده
منابع مشابه
Hypersonic Flow with Strong Blowing
A validation study is presented for a numerical code which calculates a two-dimensional steady-state solution for inviscid hypersonic flows in the presence of strong surface blowing. A higher-orde: Godunov-type finite-volume approach is used to discretize the inviscid Euler equations. Interface values of the state quantities are reconstructed nsing a monotone interpolation technique suggested b...
متن کاملHeat Transfer on a Hypersonic Sphere with Gas Injection
The interaction of a diffusing outgas flow from a sphere nose opposing a hypersonic free stream is studied numerically using the direct simulation Monte-Carlo technique under the transitional rarefied-gas-flow regime conditions at Knudsen numbers from 0.016 to 1.5 and blowing factors from 0.15 to 1.5. Strong influences of the blowing factor (the ratio of outgas mass flux to upstream mass flux) ...
متن کاملDirect Numerical Simulation and Theoretical Analysis of Perturbations in Hypersonic Boundary Layers
Direct numerical simulations of receptivity in a boundary layer over a flat plate and a sharp wedge were carried out with two-dimensional perturbations introduced into the flow by periodic-in-time blowing-suction through a slot. The free stream Mach numbers are equal to 5.92 and 8 in the cases of adiabatic flat plate and sharp wedge, respectively. The perturbation flow field was decomposed into...
متن کاملDirect numerical simulation and the theory of receptivity in a hypersonic boundary layer
Direct numerical simulation of receptivity in a boundary layer over a sharp wedge of half-angle 5.3 degrees is carried out with two-dimensional perturbations introduced into the flow by periodic-in-time blowing-suction through a slot. The freestream Mach number is equal to 8. The perturbation flow field downstream from the slot is decomposed into normal modes with the help of the biorthogonal e...
متن کاملSTRESS INTENSITY FACTORS FOR AN INTERIOR GRIFFITH CRACK OPENED BY HEATED WEDGE IN A STRIP WHOSE EDGES ARE NORMAL TO CRACK AXIS
After second world war, we have seen a very rapid development of Thermoelasticity stimulated by various engineering sciences. As we know, structures behave in different fashion under climate variation and the most responsible factor for these variations is heat which falls through and causes deformation of the body. A considerable progress in the field of aircraft and machine structures, mainly...
متن کامل