Preparation of a new adsorbent from activated carbon and carbon nanofiber (AC/CNF) for manufacturing organic-vacbpour respirator cartridge

نویسندگان

  • Mehdi Jahangiri
  • Javad Adl
  • Seyyed Jamaleddin Shahtaheri
  • Alimorad Rashidi
  • Amir Ghorbanali
  • Hossein Kakooe
  • Abbas Rahimi Forushani
  • Mohammad Reza Ganjali
چکیده

In this study a composite of activated carbon and carbon nanofiber (AC/CNF) was prepared to improve the performance of activated carbon (AC) for adsorption of volatile organic compounds (VOCs) and its utilization for respirator cartridges. Activated carbon was impregnated with a nickel nitrate catalyst precursor and carbon nanofibers (CNF) were deposited directly on the AC surface using catalytic chemical vapor deposition. Deposited CNFs on catalyst particles in AC micropores, were activated by CO2 to recover the surface area and micropores. Surface and textural characterizations of the prepared composites were investigated using Brunauer, Emmett and Teller's (BET) technique and electron microscopy respectively. Prepared composite adsorbent was tested for benzene, toluene and xylene (BTX) adsorption and then employed in an organic respirator cartridge in granular form. Adsorption studies were conducted by passing air samples through the adsorbents in a glass column at an adjustable flow rate. Finally, any adsorbed species not retained by the adsorbents in the column were trapped in a charcoal sorbent tube and analyzed by gas chromatography. CNFs with a very thin diameter of about 10-20 nm were formed uniformly on the AC/CNF. The breakthrough time for cartridges prepared with CO2 activated AC/CNF was 117 minutes which are significantly longer than for those cartridges prepared with walnut shell- based activated carbon with the same weight of adsorbents. This study showed that a granular form CO2 activated AC/CNF composite could be a very effective alternate adsorbent for respirator cartridges due to its larger adsorption capacities and lower weight.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Investigation of hydrogen sulfide adsorption in metallic scaffold MOF-5 nanocomposite based on activated carbon for the use of respiratory mask cartridge

Introduction: Hydrogen sulfide is one of the most important impurities in natural gas. Due to the fact that this gas is hazardous, toxic, corrosive and volatile, therefore, the removal of hydrogen sulfide has been studied using several methods. One of the most known procedures is the adsorption process. In the present study, activated carbon and activated carbon-based composite scaffolds (MOF-5...

متن کامل

The kinetics of the removal of copper ions from aqueous solutions using magnetic nanoparticles supported on activated carbon

Removal of Cu(II) from aqueous solution supplies is possible through the process of adsorption. One of these processes involves the preparation of magnetic nanoparticles on activated carbon (AC). Adsorbed coppre ions on the surface of Fe3O4-AC are separated from aqueous solutions using external magnetic fields. In the present study, magnetic nanoparticles were synthesized ...

متن کامل

Investigation the Efficiency of Activated Carbon Coated with ZnO Nanoparticles Prepared by Green Synthesis Method in Removing Humic Acid from Aqueous Solutions: Kinetics and Isotherm Study

Background & objective: The presence of natural organic matter in water sources creates various problems, especially in common water treatment process. These compounds cause unfavorable taste and odor in water and are among the most important precursors of water disinfection by-products. This study was carried out to evaluate the efficiency of activated carbon (AC) and activated carbon modified...

متن کامل

Comparison of Modified Palladium Nanoparticles and Homemade Activated Carbon Derived from Medlar for Solid Phase Extraction of Metal Ions Prior to Their Flame Atomic Absorption Spectrometry Determination

This study focus on the preparation of two supports including activated carbon derived from medlar and Palladium nanoparticles loaded on activated carbon (Pd-NP-AC). Subsequently, both adsorbent modified with a novel Schiff base chelating agent and their potential applicability for determination of trace amounts of metal ions from aqueous solution has been investigated. The method is based on c...

متن کامل

Investigation of the Effect of Nanoparticles in the Cephalexin adsorption onto Walnut Shell-based Activated Carbon

Background and purpose: Recently, release of pollutants such as pharmaceuticals to the environment becomes one of the most important problems for soil and water. The present study was conducted to introduce walnut shell-based activated carbon (AC) as a new low-cost adsorbent for the removal of cephalexin (CFX) antibiotic from aqueous solutions. Materials and Methods: This study was conducted...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره 10  شماره 

صفحات  -

تاریخ انتشار 2013