Designing a Planar Antenna for Reading Device of the Capsule Endoscopic Complex
نویسندگان
چکیده
This article describes the design of a planar antenna, which consists of available small-scale antenna elements and can be used in receivers with adaptive noise reduction algorithms, in particular, the receiving antenna for capsule endoscopic system “Landish”. The entire planar antenna simulation results are described, material for common dielectric substrate is chosen. The differences between the characteristics of the radiation field in the far zone, the voltage standing wave ratio and wave resistance depending on the thickness of the substrate is noted. The finite element method was used for numerical calculations.
منابع مشابه
UWB Planar Conical Horn-Shaped Self-Complementary Bow-Tie Antenna
An ultra-wideband (UWB) self-complementary planar bow-tie antenna (SCPBTA) is proposed. The antenna consists of a printed conical horn-shaped (CHS) radiator and a counterpart CHS slot etched on a rectangular ground plane. The printed CHS radiator is connected directly to the 50Ω microstrip line by bending the end portion of the feed line. As a result, the antenna has a simple structure which do...
متن کاملDesign of an Ultra-Wideband Monopole Antenna by Using New Nano-Composite Materials
In this paper, a planar monopole antenna is introduced, also we added some new Nano fillers such as Fumed Silica and Aluminum Oxide to RT Duriod5880 and RO3003 to produce new Nano composite materials, then new Nano composite materials are used as a substrate of a ultra-wideband monopole antenna. Antenna characteristics are considered to illustrate that, by using these Nano composite materials, ...
متن کاملDesign Investigation of Microstrip Patch and Half-Mode Substrate Integrated Waveguide Cavity Hybrid Antenna Arrays
In this paper two linear arrays including a linear 1×4 and a planar 2×2 of microstrip patch and half-mode substrate integrated waveguide (SIW) cavity hybrid antenna are introduced and investigated. These are simply implemented using low cost single layer printed circuit board (PCB) process. The array element consists of a rectangular microstrip patch with appropriate dimensions in the vicinity ...
متن کاملDesigning a Multiband Multi Polarization BTS Antenna
In this paper, a new antenna is presented which has an application in cellular telecommunication systems. The designed antenna works at the frequency range of 1900-2600 MHz which is able to cover 2G, 3G and 4G (LTE) services of the cellular telecommunication. In this paper, the micro-strip structure has been used to design the antenna. The shape of the patches is triangular where a peripheral r...
متن کاملNew Low Cost Printed Antenna CPW-Fed for Global Positioning System, Personal Communication System and Worldwide Interoperability for Microwave Access Band Applications (TECHNICAL NOTE)
This paper presents a new design of a CPW-Fed multi bands planar antenna. This antenna can be integrated easily with passive and active elements. The proposed antenna is suitable to operate for GPS, PCS and WiMAX bands. Its entire area is 52.3x52.6mm2 and is employed on an FR-4 epoxy substrate and fed by a 50 Ohm coplanar line. The antenna parameters have been analyzed and optimized by using AD...
متن کامل