Non-contact Technique of Optical Fiber Coating Removal with Hot Air Stream
نویسندگان
چکیده
We will discuss a novel non-contact removal technique of optical fiber coating in continuous and uninterrupted manner with hot air stream. We observed little degradation of the tensile strength of the optical fiber after removing the protective polymer coating and the mean breaking tensile strength of the stripped optical fiber using non-contact removal method was 5.1GPa. key words: non-contact, coating, hot air stream, optical ber,
منابع مشابه
Possibility of using plasma-processed hybrid nanofibers to remove toluene in air stream
Introduction: Despite nanofibers have attracted great interests for filtering particulate matters from the air stream, fewer studies have been done on the feasibility of their use in the removal of gas pollutants, while the both pollutants are present in the most workplaces. Toluene is a toxic and mutagenic substance, and chronic exposure to its low levels can lead to a wide range of adverse he...
متن کاملAn Optical Fiber Sensor Probe Using a PMMA/CPR Coated Bent Optical Fiber as a Transducer for Monitoring Trace Ammonia
Ammonia sensors have broad spectrum of applications for industrial process control as well as for environmental monitoring. An optical fiber ammonia sensor probe has been developed by using a bent optical fiber having dual poly(methyl methacrylate) (PMMA)/chlorophenol red (CPR) coatings as a transducer. This sensor probe was tested for monitoring trace ammonia in gas samples using air as sample...
متن کاملOptical Fiber Humidity Sensor Based on Lossy Mode Resonances
A novel optical fiber humidity sensor based on lossy mode resonances (LMR) has been developed. LMRs are supported here by a thin Indium Tin Oxide (ITO) coating fabricated onto an optical fiber core via a sol-gel dip coating. ITO coated optical fiber devices present a resonant maximum absorption peak in the infra-red region which is shifted to higher wavelengths when the refractive index of the ...
متن کاملAll-optical fiber anemometer based on laser heated fiber Bragg gratings.
A fiber-optic anemometer based on fiber Bragg gratings (FBGs) is presented. A short section of cobalt-doped fiber was utilized to make a fiber-based "hot wire" for wind speed measurement. Fiber Bragg gratings (FBGs) were fabricated in the cobalt-doped fiber using 193 nm laser pulses to serve as localized temperature sensors. A miniature all-optical fiber anemometer is constructed by using two F...
متن کاملEvaluation of Photocatalytic Activity of Fe Doped TiO2 Thin Film Prepared by sol-gel hot dip-coating
The application of Fe–TiO2 photocatalysis using sol–gel method by hot–dipping technique was investigated. Then, the influences of fabrication parameters, molar ratios of Fe to TiO2, the sol temperature, poly ethylene glycol (PEG) content and the number of dipping cycles on the photocatalytic activity in visible light region were mainly studied. The experimental results revealed the sample with ...
متن کامل