Consistent Derivations of Spring Rates for Helical Springs
نویسنده
چکیده
The spring rates of a coiled helical spring under an axial force and an axially directed torque are derived by a consistent application of Castigliano’s second theorem, and it is shown that the coupling between the two loads may not always be neglected. The spring rate of an extensional spring is derived for the first time through the use of the displacement based principle of minimum total potential energy. The present results are also compared with available derivations of and expressions for the stiffness of a coiled spring. DOI: 10.1115/1.3125888
منابع مشابه
Gamma Dose Rate Measurement and Dose Rate Calculation for Sensitive Organs in the Vicinity of Hot Springs in Kerman Province
Introduction: All of the people worldwide are exposed to low levels of radiation. Cancer induction and genetic disorders are among the hazards of low level exposure. In some cases, radiation close to hot springs is higher than normal areas due to a high concentration and the decay products of Ra-226. Given the use of hot springs by the general public because of their therapeutic p...
متن کاملAnalysis of Dynamic Stiffness Effect of Primary Suspension Helical Springs on Railway Vehicle Vibration
Helical springs within the primary suspension are critical components for isolating the whole vehicle system from vibration generated at the wheel/rail contact. As train speeds increase, the frequency region of excitation becomes larger, and a simplified static stiffness can no longer represent the real stiffness property in a vehicle dynamic model. Coil springs in particular exhibit strong int...
متن کاملA Computational Approach for Evaluating Helical Compression Springs
Helical compression springs are generally synthesized and evaluated by determining the maximum torsional stress, fatigue life, natural frequency, and/or load loss due to stress relaxation. To this end, researchers have developed finite element analysis (FEA) modeling methods to simulate the design performance of helical compression springs. The intent of this paper was to make a useful contribu...
متن کاملMechanics of patterned helical Si springs on Si substrate.
The elastic response, including the spring constant, of individual Si helical-shape submicron springs, was measured using a tip-cantilever assembly attached to a conventional atomic force microscope. The isolated, four-turn Si springs were fabricated using oblique angle deposition with substrate rotation, also known as the glancing angle deposition, on a templated Si substrate. The response of ...
متن کاملCascade unlooping of a low-pitch helical spring under tension
We study the force vs extension behaviour of a helical spring made of a thin torsionally-stiff anisotropic elastic rod. Our focus is on springs of very low helical pitch. For certain parameters of the problem such a spring is found not to unwind when pulled but rather to form hockles that pop-out one by one and lead to a highly non-monotonic force-extension curve. Between abrupt loop pop-outs t...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2009