Modulated Ramp PWM Generator for Linear Control of the Boost Converter’s Power Stage
نویسنده
چکیده
In this paper, the concept of the modulated-ramp PWM generator is presented. The specific nonlinear behavior of this generator enables an exact linear control-to-output static conversion characteristic of DC-DC switching converters, such as the boost (step-up), buck/boost, Ćuk or Sepic, operating in Continuous Conduction Mode (CCM). The resulting linearization leads to a significant improvement of the control accuracy, and simplification of the converters, operating mainly in the open-loop architecture. In this paper, the concept of the modulated-ramp PWM generator is described, followed by a detailed steady-state and small-signal AC analysis. The key aspects for practical implementation are also highlighted. All results and benefits of the modulated-ramp PWM generator are demonstrated here on the boost converter power stage.
منابع مشابه
Low-Power CMOS Ramp Generator Circuit for DC-DC Converters
Ramp-signal generators are particularly critical in controlling the frequency and dutycycle of pulse-width modulated (PWM) switching supplies. They are normally implemented with a timed charging current source into a capacitor and a reset switch controlled by two comparators whose reference signals set the lower and upper limits of the ramp. A fast comparator is required to ensure the reset ope...
متن کاملImprovement Performances of Active and Reactive Power Control Applied to DFIG for Variable Speed Wind Turbine Using Sliding Mode Control and FOC
This paper deals with the Active and Reactive Power control of double-fed induction generator (DFIG) for variable speed wind turbine. For controlling separately the active and the reactive power generated by a DFIG, field oriented control (FOC) and indirect sliding mode control (ISMC) are presented. These non linear controls are compared on the basis of topology, cost, efficiency. The main cont...
متن کاملA Digital Pulse-Width Modulation Controller for High-Temperature DC-DC Power Conversion Application
This paper presents a digital non-linear pulse-width modulation (PWM) controller in a high-voltage (HV) buck-boost DC-DC converter for the piezoelectric transducer of the down-hole acoustic telemetry system. The proposed design controls the generation of output signal with voltage higher than the supply voltage and is targeted to work under high temperature. To minimize the power consumption an...
متن کاملMitigation of Switching Harmonics in Shunt Active Power Filter Based on Variable Structure Control Approach
This paper presents a novel control approach used in shunt active power filter based on variable structure control combined with Random PWM technique (RVSC) that provides robust, fast, and more favorable performance for active power filter. This control strategy is compared with two other strategies to show the effectiveness of the introduced methods; pulse width modulated proportional-integral...
متن کاملActive and Reactive Power Management of Wind Farm Based on a Six Leg Tow Stage Matrix Converter Controlled by a Predictive Direct Power Controller
In this paper we propose a new configuration of the wind farm connecting with an electrical grid. The proposed Wind Energy Conversion System (WECS) is based on a two stages six-leg matrix converter using to drive a two Doubly Fed Induction Machines operating at different wind speeds. Each Doubly Fed Induction Generator (DFIG) is controlled through the rotor currents using the Finite Set Model P...
متن کامل