A Review Paper on Frequency Compensation of Transconductance Operational Amplifier (OTA)
نویسنده
چکیده
In this brief, types of frequency compensation for operation transconductance amplifier are explained in detail. Compensation which is used to enhance frequency stability of the OTA, and to make gain and phase linear for required frequency range. As we know capacitor inside the OTA causes output to lag behind by 90° with each pole they create, If the addition of these phase lags add-up to 360°, the output signal will be in phase with the input signal. Feeding output signal back in proportion to input when the gain of the amplifier is sufficient will cause the amplifier to oscillate. To avoid such undesirable condition frequency compensation is required in OTA, the frequency compensation is used to make a particular pole dominant on other poles to make the transfer function 2nd order.
منابع مشابه
Operational Transconductance Amplifier for Highly Linear Application
–This paper presents a highly linear Operational Transconductance Amplifier (OTA) that combines two linearization techniques, one with adaptive biasing of differential pairs and second with resistive source degeneration. The Operational Transconductance Amplifier has ±0.9v power supply. Operational Transconductance Amplifier has been simulated with TANNER 0.18μm CMOS technology in Tspice. The s...
متن کاملDesign of a high frequency low voltage CMOS operational amplifier
A method is presented in this paper for the design of a high frequency CMOS operational amplifier (OpAmp) which operates at 3V power supply using tsmc 0.18 micron CMOS technology. The OPAMP designed is a two-stage CMOS OPAMP followed by an output buffer. This Operational Transconductance Amplifier (OTA) employs a Miller capacitor and is compensated with a current buffer compensation technique. ...
متن کاملTunable ultralow voltage transconductance amplifier and GmC filter
This paper presents a fully differential dualended ultralow-voltage (ULV) FGUVMOS operational transconductance amplifier (FGUVMOS-OTA), and a Gm-C filter where the FGUVMOS-OTA is used. The OTA has no internal nodes, rail-to-rail operation and dynamic load. The cut-off frequency of the Gm-C filter is tunable over more than 5 decades. The circuits may be operated with supply voltages down to 200mV.
متن کاملTunable floating-gate low-voltage transconductor
This paper presents a 6 transistor fully differential dualended low-voltage (ULV) FGUVMOS operational transconductance amplifier (FGUVMOS-OTA), and a Gm-C filter where the FGUVMOS-OTA is used. The OTA has rail-torail operation. A basic Gm-C filter implemented with the OTA is presented. The cut-off frequency of the filter is tunable over almost 6 decades with a supply voltage below 1V.
متن کاملElectronically Tunable Signal Processing Circuit
This paper presents a voltage mode universal filter using two multi-output operational transconductance amplifier (OTA). Proposed multi-input single output universal filter employs two capacitors only and realizes all the standard second order filtering functions from same configuration. Filter parameters namely pole frequency and quality factor can be tuned independently without affecting each...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2015