Quantification and aging of the post-blast residue of TNT landmines.
نویسندگان
چکیده
Post-blast residues are potential interferents to chemical detection of landmines. To assess the potential problem related to 2,4,6-trinitrotoluene (TNT), its post-blast residue was identified and quantified. In the first part of this study laboratory-scale samples of TNT (2 g) were detonated in a small-scale explosivity device (SSED) to evaluate the explosive power and collect post-blast residue for chemical analysis. Initiator size was large relative to the TNT charge; thus, issues arose regarding choice of initiator, residue from the initiator, and afterburning of TNT. The second part of this study detonated 75 to 150 g of military-grade TNT (typical of antipersonnel mines) in 55-gal barrels containing various witness materials (metal plates, sand, barrel walls, the atmosphere). The witness materials were analyzed for explosive residue. In a third set of tests, 75-g samples of TNT were detonated over soil (from Fort Leonard Wood or Sandia National Laboratory) in an indoor firing chamber (100 by 4.6 by 2.7 m high). Targeted in these studies were TNT and four explosive-related compounds (ERC): 2,4-dinitrotoluene (DNT), 1,3-dinitrobenzene (DNB), 2- and 4-aminodinitrotoluene (2-ADNT and 4-ADNT). The latter two are microbial degradation products of TNT. Post-blast residue was allowed to age in the soils as a function of moisture contents (5 and 10%) in order to quantify the rate of degradation of the principal residues (TNT, DNT, and DNB) and formation of the TNT microbial degradation products (2-ADNT and 4-ADNT). The major distinction between landmine leakage and post-blast residue was not the identity of the species but relative ratios of amounts. In landmine leakage the DNT/TNT ratio was usually greater than 1. In post-blast residue it was on the order of 1 to 1/100th of a percent, and the total amount of pre-blast residue (landmine leakage) was a factor of 1/100 to 1/1000 less than post-blast. In addition, landmine leakage resulted in low DNT/ADNT ratios, usually less than 1, whereas pre-blast residues started with ratios above 20. Because with time DNT decreased and ADNT increased, over a month the ratio decreased by a factor of 2. The rate of TNT degradation in soil observed in this study was much slower than that reported when initial concentrations of TNT were lower. Degradation rates yielded half-lives of 40 and 100 days for 2,4-DNT and TNT, respectively.
منابع مشابه
EXPERIMENTAL EVALUATION OF BLAST WAVE PARAMETERS IN UNDERWATER EXPLOSION OF HEXOGEN CHARGES
Behavior of blast wave in underwater explosion is of interest to metal forming community and ship designers. Underwater detonation is, also a potential hazard to the water intakes or a plant spent fuel pool. In this paper, some techniques for calculating free-field blast parameters such as pressure and impulse in underwater explosion and prediction of bubble pulsation parameters are presented a...
متن کاملQuantification of the Air Blast Characteristics of Commercial Explosives
The pressure-time profiles produced by initiation in free-air of four commercial sector explosives covering a range of velocities of detonation are reported. The results indicate that there are no significant differences in the blast wave shapes from the explosives when measured between 5 and 20 m from the initiation point. The dependence of peak overpressure and positive phase impulse on scale...
متن کاملبررسی خواص مکانیکی و عملکردی خرج ترموباریک PBXIH-135
Thermobaric charge PBXIH-135 is an explosive with desirable mechanical and safety characteristics. In present research, this PBX charge is provided on scale of 2 kg and its physical, mechanical, sensitivity and performance parameters were investigated. Prepared sample has density of 1.64 g/cm3, hardness of 53 Shore A, tensional strength of 1.68 MPa and strain of 44%. Impact and friction sensiti...
متن کاملComparison between Alternative Load Path Method and a Direct Applying Blast Loading Method in Assessment of the Progressive Collapse
Extensive research has been focused on the progressive collapse analysis of buildings and most of them are based on the alternative path method (APM) with sudden removal of one or several columns. However, in this method the damage of adjacent elements of removed columns under blast conditions was ignored and this issue can lead to an incorrect prediction of progressive collapse. Therefore, in ...
متن کاملSimulation of the Reactive Powder Concrete (RPC) Behavior Reinforcing with Resistant Fiber Subjected to Blast Load
In research or experimental works related to blast loads, the amount of explosion material and distance of explosion point are very important. So, in this paper has been attempted to present a parametric study of the reactive powder concrete subjected to blast load. The effect of the different amount of TNT adopted the literature, distance of explosion point from RPC slab and also the location ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- Journal of forensic sciences
دوره 48 4 شماره
صفحات -
تاریخ انتشار 2003