Mode Shape Vibration Analysis of Truck Transmission Housing Based on FEA
نویسندگان
چکیده
The main objective of this research work is to find the natural frequency and mode shape of truck transmission housing. Truck transmission housing or gearbox transmission casing is subjected to vibration induced by the excitation forces transmitted to the casing through bearings. So it is required to find the natural frequency for the accurate prediction of housing life and prevent it from fracture. Housing is made of various materials like cast iron and Al alloys. In present few composites are also available for the manufacturing of casing. The vibration analysis of transmission housing was performed by finite element simulation using ANSYS 14.5 software. The vibration mode shapes for first twenty modes were studied. The results show that the natural frequency of vibration varies from 1306.3 Hz to 3879 Hz. The analysis results were verified with experimental result available in literature. Solid Edge software is used for the designing of transmission housing and FEA based ANSYS 14.5 software is used for the free vibration analysis of transmission housing. Keywords— Truck Transmission, Housing, FEA, Structural Steel, Natural Frequency.
منابع مشابه
Modal Analysis of Heavy Vehicle Truck Transmission Gearbox Housing Made from Different Materials
Heavy vehicle truck transmission gearbox housing is subjected to load fluctuations, harmonic excitation, gear meshing excitation, gear defects, varying speed and torque conditions. Transmission errors and internal excitations are the root cause of vibration and noise. The main objective of this research work is weight calculation and modal analysis of gearbox housing. For weight calculation fou...
متن کاملStudy of Vibration Specifications of a Three-axle Truck Using Lagrange Method
In this research, Ride quality of a three-axle truck is investigated to understand its vibration specifications and influence of it on special load. The truck is Benz 2624, and the load is rather sensitive to vibrations. The system is considered for an off-road duty. Hence, the vehicle is modeled as a nineteen-degree of freedom system and its equations of motion are derived by employing Lagrang...
متن کاملAeolian Vibrations of Transmission Line Conductors with More than One Damper
To reduce the damages of aeolian vibration of conductors to the power transmission networks, the most common method is installation of Stock-bridge dampers. Estimation of the damper’s dissipated energy is an important factor in determining the number and location of installation of these types of vibration absorbers. This estimation is strongly dependent upon the assumed mode shape of the condu...
متن کاملStudy of Vibration Specifications of a Three-axle Truck Using Lagrange Method
In this research, Ride quality of a three-axle truck is investigated to understand its vibration specifications and influence of it on special load. The truck is Benz 2624, and the load is rather sensitive to vibrations. The system is considered for an off-road duty. Hence, the vehicle is modeled as a nineteen-degree of freedom system and its equations of motion are derived by employing Lagrang...
متن کاملSimulation and Experimental Study of Vibration and Noise of Pure Electric Bus Transmission based on Finite Element and Boundary Element Methods
Since the electric motor of pure electric vehicle replaced the engine, the "masking effect" disappears, and the problem of vibration and noise of the transmission becomes prominent. This is generated during the gear meshing and is transmitted to the housing through the shaft and bearing. Thereby, radiation noise of the housing are generated. The prediction and analysis...
متن کامل