Requirements Selection for Rapid Prototyping: Polyphenylsulfone as a Mold Material for Spin Casting Polyurethane Resin
نویسنده
چکیده
For the development of a rotational symmetrical polyurethane part with a steel reinforcement, a requirement/constraint driven approach to process design has been taken. In this approach a scale model of the process was built using fused deposition modeling (FDM) rapid prototyping technique, then used to validate design, material and process parameters. After selection and testing on the scaled prototype, results were used to define a full-sized spin casting mold built using Polyphenylsulfone (PPSF).
منابع مشابه
Computer aided rapid tooling process selection and manufacturability evaluation for injection mold development
Injection mold development lead time has been reduced presently by over 50% by employing rapid prototyping based tooling methods. Rapid tooling methods however, have certain limitations in terms of mold material, accuracy, surface finish, and mold life. The relevant process knowledge, especially for newer routes, is not very well established, resulting inconsistent or inappropriate rapid toolin...
متن کاملComputer aided rapid tooling process selection and manufacturability evaluation for injection mold
Injection mold development lead time has been reduced presently by over 50% by employing rapid prototyping based tooling methods. Rapid tooling methods however, have certain limitations in terms of mold material, accuracy, surface finish, and mold life. The relevant process knowledge, especially for newer routes, is not very well established, resulting inconsistent or inappropriate rapid toolin...
متن کاملDesign and Manufacture of Casting Pattern Plates by Rapid Tooling
The primary target of this project consists of combining the technique of rapid prototyping and casting to produce aluminum parts in a sand mold being made the corresponding models and core boxes by means of the technology of rapid tooling, FDM (fused deposition modeling) of ABS. The followed process to obtain the pieces is casting, that consists of the fused metal spill in a mold pattern previ...
متن کاملRapid Prototyping Process of Monocrystal Aircraft Engine Blades
The article presents pr ocess application of the rapi d prototyping (RP) for manufacturing of blades of aircraft turbine in monocrystallization and also directional crystallization of casting process. It is describing the method of modelling of the chosen elements of casting model kit with the usage of RP and RT system s. The article presents the analysis of additive rapid prototyping methods (...
متن کاملReinforcement of facial prosthetic dental stone molds.
THE JOURNAL OF PROSTHETIC DENTISTRY 113 The most commonly used molds in the subspecialty of facial prosthetics are made of dental plaster and stone. The molds’ material advantages are that they are economical, time efficient, and easy to fabricate. The disadvantages are wear with repeated use for prosthesis fabrication, they must be thoroughly dry before processing with moisture sensitive facia...
متن کامل