The Power of the Test in Three-Level Designs

نویسنده

  • Spyros Konstantopoulos
چکیده

The Power of the Test in Three-Level Designs Field experiments that involve nested structures may assign treatment conditions either to entire groups (such as classrooms or schools), or individuals within groups (such as students). Since field experiments involve clustering, key aspects of their design include knowledge of the intraclass correlation structure and the sample sizes necessary to achieve adequate power to detect the treatment effect. This study provides methods for computing power in three-level designs, where for example, students are nested within classrooms and classrooms are nested within schools. The power computations take into account clustering effects at the classroom and at the school level, sample size effects (e.g., number of students, classrooms, and schools), and covariate effects (e.g., pre-treatment measures). The methods are generalizable to quasi-experimental studies that examine group differences in an outcome, or associations between predictors and outcomes. JEL Classification: C9

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Design of a low power high speed 4-2 compressor using CNTFET 32nm technology for parallel multipliers

In this article a low power and low latency 4-2 compressor has been presented. By using modified truth table and Pass Transistor Logic (PTL) a novel structure has been proposed which outperforms previous designs from the frequency of operation view point. The proposed design method has reduced the total transistor count considerably which will lead to reduced power consumption and smaller activ...

متن کامل

Design of a low power high speed 4-2 compressor using CNTFET 32nm technology for parallel multipliers

In this article a low power and low latency 4-2 compressor has been presented. By using modified truth table and Pass Transistor Logic (PTL) a novel structure has been proposed which outperforms previous designs from the frequency of operation view point. The proposed design method has reduced the total transistor count considerably which will lead to reduced power consumption and smaller activ...

متن کامل

Proposed Procedure for Estimating the Coefficient of Three-factor Interaction for 2^p 3^m 4^q Factorial Experiments (TECHNICAL NOTE)

Three-factor interaction for the two-level, three-level, and four-level factorial designs was studied. A new technique and formula based on the coefficients of orthogonal polynomial contrast were proposed to calculate the effect of the three-factor interaction The results show that the proposed technique was in agreement with the least squares method. The advantages of the new technique are 1) ...

متن کامل

Comparison of the Effect of Ball and Bar Attachment Designs on Retention and Stability of Mandibular Implant-Supported Overdentures

Objectives: The present study evaluated the effect of bar and ball attachment designs on retention and stability of a mandibular overdenture supported by four implants. Methods: An edentulous mandibular acrylic resin model with four implants in the anterior part of the ridge (A, B, D and E) was fabricated. A metal framework simulating the overdenture was also fabricated. Totally, 30...

متن کامل

Influence of Fault Current Limiter in Voltage Drop and TRV Considering Wind Farm

Influence of distributed generation systems in the distribution systems can increase the level of short-circuit current. The effectiveness of distributed generation systems is affected by the size, location, type of distributed generation systems technology, and the methods of connecting to distribution systems. Wind turbine system is the examples of distributed generation source. Not only does...

متن کامل

Fitting Second-order Models to Mixed Two-level and Four-level Factorial Designs: Is There an Easier Procedure?

Fitting response surface models is usually carried out using statistical packages to solve complicated equations in order to produce the estimates of the model coefficients. This paper proposes a new procedure for fitting response surface models to mixed two-level and four-level factorial designs. New and easier formulae are suggested to calculate the linear, quadratic and the interaction coeff...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2006