Vector Modulator for Phase Shifting in Passive Beamforming Wireless Systems
نویسندگان
چکیده
This paper proposes vector modulator for changing the phase of a signal in passive beamforming system. Vector modulator is used to perform a phase shift function with added benefit of amplitude control. It is used to improve the directivity of RF waves in Wireless systems. Vector modulator is implemented for a center frequency of 902.5 MHz. The simulation is performed for individual blocks of the vector modulator and for vector modulator with JFET and MOSFET as controlling device in the variable attenuator of the vector modulator.
منابع مشابه
A 1.5-to-5.0GHz input-matched +2dBm P1dB all-passive switched-capacitor beamforming receiver front-end in 65nm CMOS
Phased arrays in CMOS for consumer communication bands aim to enhance receiver performance by exploiting beamforming with antenna arrays. Sensitivity increases with the number of antenna elements through array gain and interferers can be cancelled through the spatial filtering of the beam pattern [1]. For the latter, the linearity of the receiver before the beamforming summing point becomes a b...
متن کاملA 1 . 0 - to - 2 . 5 GHz Beamforming Receiver with Constant - G m Vector Modulator Consuming < 9 mW per Antenna Element in 65 nm
Beamforming phased-array receivers aim to increase receiver sensitivity and reject interferers in the spatial domain [1]. A receiver with programmable phase shift and high linearity is crucial to cope with interference. Switched-capacitor vector modulators can provide adequate phase shift and linearity [3,4], but so far, at the cost of a high power consumption. As power consumption increases li...
متن کاملTransmit Beamforming with Reduced Channel Information in OFDM Based Wireless Systems
In this paper, we consider transmit beamforming that works with reduced channel state information in OFDM based multiple-input single-output (MISO) wireless systems. The proposed scheme significantly reduces the amount of feedback signaling burden by generating beamforming weights using information on the previous beamforming weights and channel correlation. The feedback signaling overhead is f...
متن کاملActuation command circuit for 60GHz RF MEMS phase shifters
This paper presents the design and realization of a low power, high speed circuit used to actuate RF MEMS (Radio Frequency MicroElectroMechanical Systems) based phase shifters at 60GHz.The phase shifter are used to realize beam forming reconfigurable antenna for high data rate WPAN (Wireless Personal Area Network) applications. RF MEMS commonly have high actuation voltages usually obtained with...
متن کاملTuning of fuzzy controller coefficients in direct torque control with space vector modulator for the three phase induction motors drive using Metaheuristic algorithms with considering electrical faults.
Among all the drive control methods of induction motors, the Direct Torque Control (DTC) method operates independently of the rotor parameters of the machine and, despite its simplicity, provides good torque control in both stable and transient modes. The use of residual comparators in these drives reduces the torque ripple and variable switching frequency. The most common solution is the use o...
متن کامل