A Systematic Analysis of Measurement Selection Algorithms for Fault Isolation in Dynamic Systems
نویسندگان
چکیده
Fault detection and isolation in dynamic physical systems based on analysis of transient system behavior involves monitoring for deviations and linking observed deviations to changes in system parameters. Components linked to the changed parameter values may be faulty. Functional redundancy is exploited in choosing measurements to uniquely isolate all faults. Measurement selection algorithms determine the minimum set of system variables that can uniquely identify all single faults in the system. This paper analyzes a set of measurement selection algorithms in the context of transient analysis in dynamic systems. Results show that an A-search algorithm provides good results while considerably reducing the computational complexity of the measurement selection process.
منابع مشابه
Optimal Current Meter Placement for Accurate Fault Location Purpose using Dynamic Time Warping
This paper presents a fault location technique for transmission lines with minimum current measurement. This algorithm investigates proper current ratios for fault location problem based on thevenin theory in faulty power networks and calculation of short circuit currents in each branch. These current ratios are extracted regarding lowest sensitivity on thevenin impedance variations of the netw...
متن کاملDesign of nonlinear parity approach to fault detection and identification based on Takagi-Sugeno fuzzy model and unknown input observer in nonlinear systems
In this study, a novel fault detection scheme is developed for a class of nonlinear system in the presence of sensor noise. A nonlinear Takagi-Sugeno fuzzy model is implemented to create multiple models. While the T-S fuzzy model is used for only the nonlinear distribution matrix of the fault and measurement signals, a larger category of nonlinear systems is considered. Next, a mapping to decou...
متن کاملInvestigation of seismic damage index due to water level changes in reservoir through nonlinear dynamic analysis under Far-Fault and Near-Fault ground motions
In this study, reservoir water level effects on nonlinear dynamic response of concrete gravity dams are investigated. For this purpose, the nonlinear behavior of the dam concrete is captured using the concrete damage plasticity (CDP) on the non associated flow rule assumption. Water in the reservoir is represented by the Lagrangian (displacement-based) fluid finite elements. The program ABAQUS ...
متن کاملFault Type Estimation in Power Systems
This paper presents a novel approach for fault type estimation in power systems. The Fault type estimation is the first step to estimate instantaneous voltage, voltage sag magnitude and duration in a three-phase system at fault duration. The approach is based on time-domain state estimation where redundant measurements are available. The current based model allows a linear mapping between the m...
متن کاملSBT soft fault diagnosis in analog electronic circuits: a sensitivity-based approach by randomized algorithms
This paper addresses the fault diagnosis issue based on a simulation before test philosophy in analog electronic circuits. Diagnosis, obtained by comparing signatures measured at the test nodes with those contained in a fault dictionary, allows for sub-systems testing and fault isolation within the circuit. A novel method for constructing the fault dictionary under the single faulty component/u...
متن کامل