Modelling and Analysis of High Pressure Peaking Switch
نویسندگان
چکیده
This paper presents modelling and analysis of peaking switch used in Marx generator, such that the rise time of the pulse produced by the Marx generator is reduced substantially. Towards this FEMM ( Finite Element Methods Magnetics) software is used for the field modelling of the switch and MATLAB for circuit modelling to observe the rise time. The switch has to produce pulse with sub-nanosecond rise time, hence the electrode distance has to be minimum. This switch can withstand high voltage only under high pressure. A mathematical model is simulated in MATLAB to see the performance under high pressure.
منابع مشابه
Peaking Attenuation in High-Gain Observers Using Adaptive Saturation: Application to a Ball and Wheel System
Despite providing robustness, high-gain observers impose a peaking phenomenon, which may cause instability, on the system states. In this paper, an adaptive saturation is proposed to attenuate the undesirable mentioned phenomenon in high-gain observers. A real-valued and differentiable sigmoid function is considered as the saturating element whose parameters (height and slope) are adaptively tu...
متن کاملAnalysis and Design of High Gain, and Low Power CMOS Distributed Amplifier Utilizing a Novel Gain-cell Based on Combining Inductively Peaking and Regulated Cascode Concepts
In this study an ultra-broad band, low-power, and high-gain CMOS Distributed Amplifier (CMOS-DA) utilizing a new gain-cell based on the inductively peaking cascaded structure is presented. It is created bycascading of inductively coupled common-source (CS) stage and Regulated Cascode Configuration (RGC).The proposed three-stage DA is simulated in 0.13 μm CMOS process. It achieves flat and high ...
متن کاملDesign of Arrayed Waveguide Grating based Optical Switch for High Speed Optical Networks
This paper demonstrates the design of an Arrayed Waveguide Gratings (AWG) based optical switch. In the design both physical and network layer analysis is performed. The physical layer power and noise analysis is done to obtain Bit Error Rate (BER). This has been found that at the higher bit rates, BER is not affected with number of buffer modules. Network layer analysis is done to obtain perfor...
متن کاملDesign and simulation of a RF MEMS shunt capacitive switch with low actuation voltage, low loss and high isolation
According to contact type, RF MEMS switches are generally classified into two categories: Capacitive switches and Metal-to-Metal ones. The capacitive switches are capable to tolerate a higher frequency range and more power than M-to-M switches. This paper presents a cantilever shunt capacitive RF MEMS switch with characteristics such as low trigger voltage, high capacitive ratio, short switchin...
متن کاملFully Distributed Modeling, Analysis and Simulation of an Improved Non-Uniform Traveling Wave Structure
Modeling and simulation of communication circuits at high frequency are important challenges ahead in the design and construction of these circuits. Knowing the fact that the lumped element model is not valid at high frequency, distributed analysis is presented based on active and passive transmission lines theory. In this paper, a lossy transmission line model of traveling wave switch (TWSW) i...
متن کامل