An Improved Experimental Test Set-up to Study the Performance of Granular Columns
نویسندگان
چکیده
This paper describes an innovative design of a newly developed large test setup for testing the performance of footings supported on soft clay reinforced with granular columns. This advanced testing method is used to examine the settlement of footings supported on granular columns. Two important features of the equipment are a the axial loading system which allows samples to be consolidated under Ko condition while the load is applied onto a small foundation area of the sample, and b a relatively large sample size of 300-mm diameter and 400-mm high. The system is also equipped with pressure cells located beneath the footing and top cap to measure the pressure distribution with respect to foundation displacement and a lateral strain gage to monitor boundary effects. This paper reports on some of the early findings from the preliminary tests carried out using this equipment. Samples for testing were prepared by consolidating kaolin slurry in a large one-dimensional consolidation chamber. The granular columns were installed using the replacement method by compacting crushed basalt uniformly graded with 90 % between 1.5–2-mm particle sizes into a preformed hole. The preliminary tests have yielded promising results, validating the functionality of the equipment and support the prospect of increasing the knowledge with respect to settlement response and design of a footing supported on granular columns.
منابع مشابه
Axial Compressive Strength of Reinforced Concrete Columns Wrapped with Fiber Reinforced Polymers (FRP)
This paper presents the results of a study on the axial compressive strength of columnsstrengthened with FRP wrap. The experimental part of the study included testing 6 reinforcedconcrete columns in two series. The first series comprised three similar circular reinforced concretecolumns strengthened with FRP wrap. The second series consisted of three similar square columns,two with sharp corner...
متن کاملA New model of Equivalent Modulus Derived from Repeated Load CBR Test
This paper presents a new model of equivalent modulus derived from the Repeated Load CBR (RL-CBR) test without strain gauge. This model is an updated version of Araya et al. model (2011), the update consists of using the vertical strain as weighting factor instead of vertical displacement in the mean vertical and horizontal stresses calculation. The accuracy of equivalent modulus was improved b...
متن کاملAn Experimental Correlation for Friction Factor in Horizontal Pipe with Trapezoidal Section Inner Longitudinal Slots for Conveying of Solids
In order to increase the efficiency of the conveyance of the granular solids, a new experimental set-up is designed. The test rig has longitudinal trapezoidal slots in its conveying pipes. Through experimentation, a correlation for friction factor in terms of solid mass flow rate, fluid flow rate and Froude number is presented. It is shown that the mixture friction factor for pipes with inn...
متن کاملHydrogen sulfide removal from biogas using chemical absorption technique in packed column reactors
The toxicity and corrosion potential of hydrogen sulfide in raw biogas underlines the need for biogas purification. Several techniques available for removal of hydrogen sulfide from biogas are out of the reach for common end users due to lack of knowledge, higher running costs, and insufficient operational skills. The present experimental study aims to propagate hydrogen sulfide removal techniq...
متن کاملExperimental and Numerical study of earth slope reinforcement using ordinary and rigid stone columns
Earth slopes stabilization is one of the main issues focused on by are in geotechnical engineer. Use of stone columns is one of approaches well increasing the safety factor of earth slopes of the soil embankments; furthermore, it is economical besides the simplicity and ease it exhibits in implementation. . The present paper aims at an experimental comparison of the Ordinary Stone Column (OSC) ...
متن کامل