Speed -Sensorless Vector Control of Parallel Connected Induction Motor Drive Fed by a Single Inverter using Natural Observer
نویسندگان
چکیده
This paper describes the speed sensorless vector control method of the parallel connected induction motor drive fed by a single inverter. Speed and rotor fluxes of the induction motor are estimated by natural observer with load torque adaptation and adaptive rotor flux observer. The performance parameters speed and rotor fluxes are estimated from the measured terminal voltages and currents. Fourth order induction motor model is used and speed is considered as a parameter. The performance of the natural observer is similar to the conventional observer. The speed of an induction motor is estimated by MATLAB simulation under different speed and load conditions. Estimated values along with other measured states are used for closed loop control. The simulation results show that the natural observer is also effective for parallel connected induction motor drive. Keywords—natural observer, adaptive observer, sensorless control
منابع مشابه
Single Inverter Fed Speed Sensorless Vector Control of Parallel Connected Two Motor Drive
This paper describes a speed sensorless vector control method of the torque for cost-effective parallel-connected dual induction motor fed by a single inverter. A natural observer with load torque adaptation is employed to estimate the speeds of the same rating induction motors connected in parallel and fed by a single inverter. The speed difference between the two induction motors for unbalanc...
متن کاملA Current-Based Output Feedback Sliding Mode Control for Speed Sensorless Induction Machine Drive Using Adaptive Sliding Mode Flux Observer
This paper presents a new adaptive Sliding-Mode flux observer for speed sensorless and rotor flux control of three-phase induction motor (IM) drives. The motor drive is supplied by a three-level space vector modulation (SVM) inverter. Considering the three-phase IM Equations in a stator stationary two axis reference frame, using the partial feedback linearization control and Sliding-Mode (SM) c...
متن کاملSensorless Speed and Position Control with DTFC of Induction Motor using Four Switch Three Phase Inverter and Adaptive Flux Observer
This paper presents sensor-less speed control of induction motor (IM) using four switch three phase inverter (FSTPI) with direct torque and flux control (DTFC). The proposed sensor-less DTFC system consists of an adaptive observer of rotor flux to accurately estimate stator resistance and speed simultaneously, without affecting drive performances. The switching technique for DTFC of IM using FS...
متن کاملInfluence of Constant Values and Motor Parameters Deviations on the Performance of the Adaptive Sliding-mode Observer in a Sensorless Induction Motor Drive
The adaptive sliding-mode observer has been widely used to estimate the rotor flux and rotor speed in inverter-fed sensorless induction motor drives. However, the technique requires setting a priori the sliding-mode observer constants and also knowledge of the induction motor parameters. This particular aspect can cause significant errors in the estimation of the rotor speed used in sensorless ...
متن کاملIncreasing the Efficiency of the Power Electronic Converter for a Proposed Dual Stator Winding Squirrel-Cage Induction Motor Drive Using a Five-Leg Inverter at Low Speeds
A dual stator winding squirrel-cage induction motor (DSWIM) is a brushless single-frame induction motor that contains a stator with two isolated three-phase windings wound with dissimilar numbers of poles. Each stator winding is fed by an independent three-phase inverter. The appropriate efficiency of this motor is obtained when the ratio of two frequencies feeding the machine is equal to the r...
متن کامل