On Reliability of (n + 1)-Unit Warm Standby System based on Imperfect Repair Facility and Two Types of Failures
نویسندگان
چکیده
R. K. Agnihotri and S. K. Statsangi, Analysis of a two-unit redundant system with optimum interchangement time, Reliab. 35 (1995), no. 4, 749–750. B. S. Dhilon, Om human reliability bibliography, Microelectron. Reliab. 20 (1980), 371–373. B. S. Dhilon, Stochastic models for predicting human reliability, Microelectron. Reliab. 22 (1982), 491–496. B. S. Dhilon and R. B. Mishra, Reliability evaluation of system with critical human
منابع مشابه
Fault tolerant system with imperfect coverage, reboot and server vacation
This study is concerned with the performance modeling of a fault tolerant system consisting of operating units supported by a combination of warm and cold spares. The on-line as well as warm standby units are subject to failures and are send for the repair to a repair facility having single repairman which is prone to failure. If the failed unit is not detected, the system enters into an unsafe...
متن کاملPerformance Analysis of a Repairable Robot Safety System with Standby, Imperfect Coverage and Reboot Delay
The present study deals with a robot safety system composed of standby robot units and inbuilt safety unit. When the main operative unit fails, it is replaced by the standby robot unit available in the system. The concept of reboot delay is also incorporated in this study according to which the robot unit is rebooted if it is not successfully recovered. The recovery and reboot times of failed u...
متن کاملReliability Analysis of Redundant Repairable System with Degraded Failure
This investigation deals with the transient analysis of the machine repair system consisting of M-operating units operating under the care of single repairman. To improve the system reliability/availability, Y warm standby and S cold standby units are provided to replace the failed units. In case when all spares are being used, the failure of units occurs in degraded fashion. In such situation ...
متن کاملAvailability of 3-out-of-4:G Warm Standby System
Standby techniques are used to improve system availability. Usually, a k-out-of-n:G standby system is assumed that when an operating component fails, a standby component becomes active and the system is working if at least k components are fault-free. In general, there are three types in component standby, i.e., cold, hot and warm standby. Cold standby implies that inactive components have a ze...
متن کامل