A molecular dynamics test of the Hertz-Knudsen equation for evaporating liquids.

نویسندگان

  • Robert Hołyst
  • Marek Litniewski
  • Daniel Jakubczyk
چکیده

The precise determination of evaporation flux from liquid surfaces gives control over evaporation-driven self-assembly in soft matter systems. The Hertz-Knudsen (HK) equation is commonly used to predict evaporation flux. This equation states that the flux is proportional to the difference between the pressure in the system and the equilibrium pressure for liquid/vapor coexistence. We applied molecular dynamics (MD) simulations of one component Lennard-Jones (LJ) fluid to test the HK equation for a wide range of thermodynamic parameters covering more than one order of magnitude in the values of flux. The flux determined in the simulations was 3.6 times larger than that computed from the HK equation. However, the flux was constant over time while the pressures in the HK equation exhibited strong fluctuations during simulations. This observation suggests that the HK equation may not appropriately grasp the physical mechanism of evaporation. We discuss this issue in the context of momentum flux during evaporation and mechanical equilibrium in this process. Most probably the process of evaporation is driven by a tiny difference between the liquid pressure and the gas pressure. This difference is equal to the momentum flux i.e. momentum carried by the molecules leaving the surface of the liquid during evaporation. The average velocity in the evaporation flux is very small (two to three orders of magnitude smaller than the typical velocity of LJ atoms). Therefore the distribution of velocities of LJ atoms does not deviate from the Maxwell-Boltzmann distribution, even in the interfacial region.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Stability of an evaporating thin liquid film

We use a newly developed set of boundary conditions to revisit the problem of an evaporating thin liquid film. In particular, instead of the conventional Hertz–Knudsen– Langmuir equation for the evaporation mass flux we impose a more general equation expressing the balance of configurational momentum. This balance, which supplements the conventional conditions enforcing the balances of mass, mo...

متن کامل

Investigation of Thermodynamic Consistency Test of Carbon Dioxide (CO2) in Room-Temperature Ionic liquids using Generic van der Waals Equation of State

Thermodynamic consistency test of isothermal vapor-liquid equilibrium (VLE) data of various binary systems containing Carbon dioxide (CO2)/Room temperature ionic liquids (RTILs) have been investigated in wide ranges of pressures in each isotherm precisely. In this paper Generic van der Waals (GvdW) equation of state (EoS) coupled with modified van der Waals Berthelot mixing rule has ...

متن کامل

Modelling of Cylindrical Contact Theories ‎of Hertz and JKR for the Manipulation of ‎Biological Micro/Nanoparticles

   This paper deals with the development and modeling of cylindrical contact theories and also the simulation of contact forces to be applied in the manipulation of various biological micro/nanoparticles by means of the AFM. First, the simulation of contact forces in four environments has been carried out, which are the most commonly used fluid in biomanipulation. Then, the spherical and cy...

متن کامل

DERIVING THE EQUATION OF STATE FOR LIQUIDS AND EXTENSION OF THE PRINCIPLE OF CORRESPONDING STATES

A new simple model is introduced for a liquid and an equation of state is derived based on this model and the statistical mechanical calculations. This equation of state works well for the non-polar and slightly polar liquids. The important conclusion that may be deduced from this equation of state is that if the reduced variables of state are chosen and defined appropriately, then, the pri...

متن کامل

Finite Element Simulation of Contact Mechanics of Cancer Cells in Manipulation Based on Atomic Force Microscopy

The theory of contact mechanics deals with stresses and deformations which arise when the surfaces of two solid bodies are brought into contact. In elastic deformation contact occurs over a finite area. A regular method for determining the dimensions of this area is Hertz Contact Model. Appearance of atomic force microscope results in introduction of Contact ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • Soft matter

دوره 11 36  شماره 

صفحات  -

تاریخ انتشار 2015