Parameterizing the Difference in Cloud Fraction Defined by Area and by Volume as Observed with Radar and Lidar
نویسندگان
چکیده
Most current general circulation models (GCMs) calculate radiative fluxes through partially cloudy grid boxes by weighting clear and cloudy fluxes by the fractional area of cloud cover (Ca), but most GCM cloud schemes calculate cloud fraction as the volume of the grid box that is filled with cloud (C ). In this paper, 1 yr of cloud radar and lidar observations from Chilbolton in southern England, are used to examine this discrepancy. With a vertical resolution of 300 m it is found that, on average, Ca is 20% greater than C , and with a vertical resolution of 1 km, Ca is greater than C by a factor of 2. The difference is around a factor of 2 larger for liquid water clouds than for ice clouds, and also increases with wind shear. Using Ca rather than C , calculated on an operational model grid, increases the mean total cloud cover from 53% to 63%, and so is of similar importance to the cloud overlap assumption. A simple parameterization, Ca [1 e ( (C 1 1)] , is proposed to correct for this underestimate based on the observation that the observed relationship between the mean Ca and C is symmetric about the line Ca 1 C . The parameter f is a simple function of the horizontal (H ) and vertical (V ) grid-box dimensions, where for ice clouds f 0.0880 V 0.7696 H 0.2254 and for liquid clouds f 0.1635 V 0.6694 H . Implementing this simple parameterization, which excludes the effect of wind shear, on an independent 6-month dataset of cloud radar and lidar observations, accounts for the mean underestimate of Ca for all horizontal and vertical resolutions considered to within 3% of the observed Ca, and reduces the rms error for each individual box from typically 100% to approximately 30%. Small biases remain for both weakly and strongly sheared cases, but this is significantly reduced by incorporating a simple shear dependence in the calculation of the parameter f, which also slightly improves the overall performance of the parameterization for all of the resolutions considered.
منابع مشابه
Conditional Random Fields for Airborne Lidar Point Cloud Classification in Urban Area
Over the past decades, urban growth has been known as a worldwide phenomenon that includes widening process and expanding pattern. While the cities are changing rapidly, their quantitative analysis as well as decision making in urban planning can benefit from two-dimensional (2D) and three-dimensional (3D) digital models. The recent developments in imaging and non-imaging sensor technologies, s...
متن کاملConstructal design of tree-shaped conductive pathways for cooling a heat generating volume
Constructal design is used to study heat removal from a square heated body with a tree shaped high thermal conductivity pathways embedded in the body. The objective is to minimize the defined maximum dimensionless temperature difference for the body. The thermal conductivity of the body is low, and there is a uniform heat generation on it. The volume of the body is fixed. The amount of high con...
متن کاملQuantification of mass wasting volume associated with the giant landslide Maleh Kabood induced by the 2017 Kermanshah earthquake from InSAR
Radar sensors obtain regular and frequent radar images from which ground motion can be precisely detected using a variety of different techniques. The interferometric synthetic aperture radar (InSAR) is utilized to retrieve the spatial characteristics of the largest coseismic landslide Maleh-Kabood, induced by the Ms 7.3 Azgleh earthquake in Kermanshah Province, Iran. The available seven interf...
متن کاملExploring Gördes Zeolite Sites by Feature Oriented Principle Component Analysis of LANDSAT Images
Recent studies showed that remote sensing (RS) is an effective, efficient and reliable technique used in almost all the areas of earth sciences. Remote sensing as being a technique started with aerial photographs and then developed employing the multi-spectral satellite images. Nowadays, it benefits from hyper-spectral, RADAR and LIDAR data as well. This potential has widen its applicability in...
متن کاملPresenting a Morphological Based Approach for Filtering The Point Cloud to Extract the Digital Terrain Model
The Digital terrain model is an important geospatial product used as the basis of many practical projects related to geospatial information. Nowadays, a dense point cloud can be generated using the LiDAR data. Actually, the acquired point cloud of the LiDAR, presents a digital surface model that contains ground and non-ground objects. The purpose of this paper is to present a new approach of ex...
متن کامل