Flexible spintronic devices on Kapton
نویسندگان
چکیده
منابع مشابه
A bio-enabled maximally mild layer-by-layer Kapton surface modification approach for the fabrication of all-inkjet-printed flexible electronic devices
A bio-enabled, environmentally-friendly, and maximally mild layer-by-layer approach has been developed to surface modify inherently hydrophobic Kapton HN substrates to allow for great printability of both water- and organic solvent-based inks thus facilitating the full-inkjet-printing of flexible electronic devices. Different from the traditional Kapton surface modification approaches which are...
متن کاملHigh Performance MgO-barrier Magnetic Tunnel Junctions for Flexible and Wearable Spintronic Applications
The magnetic tunnel junction (MTJ) using MgO barrier is one of most important building blocks for spintronic devices and has been widely utilized as miniaturized magentic sensors. It could play an important role in wearable medical devices if they can be fabricated on flexible substrates. The required stringent fabrication processes to obtain high quality MgO-barrier MTJs, however, limit its in...
متن کاملFabrication of Circuits on Flexible Substrates Using Conductive SU-8 for Sensing Applications
This article describes a new low-cost rapid microfabrication technology for high-density interconnects and passive devices on flexible substrates for sensing applications. Silver nanoparticles with an average size of 80 nm were used to create a conductive SU-8 mixture with a concentration of wt 25%. The patterned structures after hard baking have a sheet resistance of 11.17 Ω /□. This conductiv...
متن کاملFlexible and Conformal Thermal Ground Planes
We report novel flexible thermal ground planes (FTGPs) based on heat pipe technology. FTGP’s effective thermal conductivities are much higher than those of copper and graphite heat spreaders’. We report mylaraluminum, copper-Kapton, and all-polymer FTGP prototypes and advanced technologies which will further enable high-performance FTGPs.
متن کاملX-ray microfocussing combined with microfluidics for on-chip X-ray scattering measurements.
This work describes the fabrication of thin microfluidic devices in Kapton (polyimide). These chips are well-suited to perform X-ray scattering experiments using intense microfocussed beams, as Kapton is both relatively resistant to the high intensities generated by a synchrotron, and almost transparent to X-rays. We show networks of microchannels obtained using laser ablation of Kapton films, ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2017