Sensitivity Improvement of Wireless Pressure Sensor by Incorporating a Saw Reflective Delay Line
نویسندگان
چکیده
this paper presents a wireless surface acoustic wave (SAW) pressure sensor on 41YX LiNbO3 for tire pressure monitoring system (TPMS) application, in which a reflective delay line composed of an interdigital transducer (IDT) and several reflectors was used as the sensor element. Using the coupling of modes (COM), the SAW reflective delay line was simulated, and the optimal design parameters were determined. The fabricated 2.4GHz SAW sensor was wirelessly characterized by the network analyzer. Sharp reflection peaks, few spurious signals, and relatively high signal-to-noise (S/N) ratio were observed. High sensitivity of 2.9 deg/kPa and good linearity were observed.
منابع مشابه
Maximum Measurement Range and Accuracy of SAW Reflective Delay Line Sensors
In a surface acoustic wave (SAW) wireless sensor with a reflective delay line structure, three reflectors are often used to eliminate 2π ambiguity of phase measurement. The maximum range of the measured parameter and the maximum accuracy have recently been attracting much research attention. In this paper, an analytical formula for all the factors influencing the measurement range and accuracy ...
متن کاملTire Pressure Measurement Using a Saw Hybrid Sensor
A tire pressure measuring system based on surface acoustic wave (SAW) sensors is presented. Since SAW sensors are powered by the energy of the RF field no battery is required, which is a major drawback of conventional systems. A successful combination of a SAW reflective delay line with a capacitive pressure sensor is shown. With a new way of matching the sensor impedance to the SAW reflector i...
متن کاملDevelopment of a Wireless and Passive SAW-Based Chemical Sensor for Organophosphorous Compound Detection
A new wireless and passive surface acoustic wave (SAW)-based chemical sensor for organophosphorous compound (OC) detection is presented. A 434 MHz reflective delay line configuration composed by single phase unidirectional transducers (SPUDTs) and three shorted reflectors was fabricated on YZ LiNbO₃ piezoelectric substrate as the sensor element. A thin fluoroalcoholpolysiloxane (SXFA) film acte...
متن کاملOptimization of Surface Acoustic Wave-Based Rate Sensors
The optimization of an surface acoustic wave (SAW)-based rate sensor incorporating metallic dot arrays was performed by using the approach of partial-wave analysis in layered media. The optimal sensor chip designs, including the material choice of piezoelectric crystals and metallic dots, dot thickness, and sensor operation frequency were determined theoretically. The theoretical predictions we...
متن کاملStatistical Errors in Remote Passive Wireless SAW Sensing Employing Phase Differences
Passive remote wireless sensing employing properties of the surface acoustic wave (SAW) has gained currency during a couple of decades to measure different physical quantities such as temperature, force (pressure, torque, and stress), velocity, direction of motion, etc. with a resolution of about 1% [1]. The basic principle utilized in such a technique combines advantages of the precise piezoel...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2008