The Early Blast Wave of the 2010 Explosion of U Scorpii
نویسنده
چکیده
Three-dimensional hydrodynamic simulations exploring the first 18 hours of the 2010 January 28 outburst of the recurrent nova U Scorpii have been performed. Special emphasis was placed on capturing the enormous range in spatial scales in the blast. The pre-explosion system conditions included the secondary star and a flared accretion disk. These conditions can have a profound influence on the evolving blast wave. The blast itself is shadowed by the secondary star, which itself gives rise to a low-temperature bow-shock. The accretion disk is completely destroyed in the explosion. A model with a disk gas density of 10 cm produced a blast wave that is collimated and with clear bipolar structures, including a bipolar X-ray emitting shell. The degree of collimation depends on the initial mass of ejecta, energy of explosion, and circumstellar gas density distribution. It is most pronounced for a model with the lowest explosion energy (10 erg) and mass of ejecta (10M⊙). The X-ray luminosities of three of six models computed are close to, but consistent with, an upper limit to the early blast X-ray emission obtained by the Swift satellite, the X-ray luminosity being larger for higher circumstellar gas density and higher ejecta mass. The latter consideration, together with estimates of the blast energy from previous outbursts, suggests that the mass of ejecta in the 2010 outburst was not larger than 10 M⊙. Subject headings: stars: novae — stars: individual (U Sco) — X-rays: binaries — shock waves — methods: numerical
منابع مشابه
EXPERIMENTAL EVALUATION OF BLAST WAVE PARAMETERS IN UNDERWATER EXPLOSION OF HEXOGEN CHARGES
Behavior of blast wave in underwater explosion is of interest to metal forming community and ship designers. Underwater detonation is, also a potential hazard to the water intakes or a plant spent fuel pool. In this paper, some techniques for calculating free-field blast parameters such as pressure and impulse in underwater explosion and prediction of bubble pulsation parameters are presented a...
متن کاملNonlinear statics analysis of on offshore jaket platform in the case of explosion
Explosion and fire on an offshore rig can lead to its minor or complete damage and sinking which means the loss of life or environmental pollution. Hence the use of techniques such as blast wall is crucial to reduce the detrimental effects. These blast walls are designed for explosion wave of length between 0.1 to 1 of load mainly to protect the personnel and critical sections. In this research...
متن کاملارائه مدل نیمه تجربی مقدار ماده منفجره بحرانی و حد شکلپذیری برای سازهی استوانهای متصل به مخروط ناقص به روش مقیاس بندی
In this study, the impulses of explosion within an aluminum truncated cone cylinder shells, effective parameters in explosion of these structures and structure effect on blast wave have been investigated. The goals of this study have listed as follows: a) determining critical value of explosives or necessary dynamic pressure for structure failure, b) formability limit during dynamical deforma...
متن کاملمروری بر روش های عددی شبیه سازی موج بلست انفجار
As the computation power developing, the simulation of the explosion blast wave becomes more accurate and much more codes and softwares designed for this purpose. Besides the numerical methods, there are some other effectives like: turbulence model, equation of state and the explosion models which affect the accuracy of the blast wave simulation results. This paper reviewed the numerical method...
متن کاملتأثیر مدلسازی تراک1 در محاسبه خواص موج بلاست ناشی از انفجار ابر هوا- سوخت
In this work the effect of the accuracy of a FAE detonation modeling on the generated blast wave is investigated. First, a one-dimensional numerical simulation with a reduced chemical kinetics of C2H2-O2-Ar, involving 25 elementary reactions, is used as the base model. The properties of the blast calculated with this model is compared with those of simpler models, the similarity solution of Tay...
متن کامل