Accelerator Modeling at SPEAR
نویسندگان
چکیده
The response matrix, consisting of the closed orbit change at each beam position monitor (BPM) due to corrector magnet excitations, was measured and analyzed in order to calibrate a linear optics model of SPEAR. The model calibration was accomplished by varying model parameters to minimize the chi-square difference between the measured and the model response matrices. The singular value decomposition (SVD) matrix inversion method was used to solve the simultaneous equations. The calibrated model was then used to calculate corrections to the operational lattice. The results of the calibration and correction procedures are presented.
منابع مشابه
- ph ] 2 0 Ju n 20 01 SLAC – PUB – 8232 August 1999 Dynamic Aperture Studies for SPEAR 3 1
The SSRL is investigating an accelerator upgrade project to replace the present 130 nm·rad FODO lattice with an 18 nm·rad double bend achromat lattice: SPEAR 3. In this paper, we review the methods used to maximize the SPEAR 3 dynamic aperture including optimization of linear optics, betatron tune, chromaticity and coupling correction, and effects of machine errors and insertion devices. Presen...
متن کاملAccelerator Modeling System for the Future*
Many computer programs and a variety of models exist for the design of accelerator lattices and the correction of errors. Many physicists contributed to this work by developing codes to suit a variety of machines. At present, we are integrating some of these codes into a unified framework to design and control any type of machine. We will refer to this system of interactive accelerator design, ...
متن کاملSHIELDING AND RADIATION PROTECTION AT THE SSRL 3 GcV INJECTOR
surface does not exceed 10 mSv. This paper describes the The Stanford Synchrotron Radiation Laboratory (SSRL) Inshielding and radiation protection at the injector. jector is comprised of a linear accelerator (linac) capable of INTRODUCTION energies 5 150 MeV, a 3 GeV booster synchrotron, and a beam line to transport the electrons into the storage ring Figure 1 shows a layout of the injector. Th...
متن کاملEffect of Insertion Devices in SPEAR 31
The SPEAR 3 upgrade lattice will provide much reduced beam emittance to increase the brightness of synchrotron radiation beams from wigglers and undulators. Seven existing insertion devices will be used in the lattice. In this paper we review the wiggler parameters, outline the wiggler compensation scheme, and evaluate wiggler effect on the optics and dynamic aperture. Presented at the 1999 IEE...
متن کاملDynamic Aperture Studies for SPEAR 3 1
The Stanford Synchrotron Radiation Laboratory is investigating an accelerator upgrade project that would replace the present 130 nm·rad FODO lattice with an 18 nm·rad double bend achromat (DBA) lattice: SPEAR 3. The low emittance design yields a high brightness beam, but the stronger focusing in the DBA lattice increases chromaticity and beam sensitivity to machine errors. To ensure efficient i...
متن کامل