Application of VSI-EBG Structure to High-Speed Differential Signals for Wideband Suppression of Common-Mode Noise
نویسندگان
چکیده
© 2013 Myunghoi Kim et al. 827 In this paper, we present wideband common-mode (CM) noise suppression using a vertical stepped impedance electromagnetic bandgap (VSI-EBG) structure for high-speed differential signals in multilayer printed circuit boards. This technique is an original design that enables us to apply the VSI-EBG structure to differential signals without sacrificing the differential characteristics. In addition, the analytical dispersion equations for the bandgap prediction of the CM propagation in the VSIEBG structure are extracted, and the closed-form expressions for the bandgap cutoff frequencies are derived. Based on the dispersion equations, the effects of the impedance ratio, the EBG patch length, and via inductances on the bandgap of the VSI-EBG structure for differential signals are thoroughly examined. The proposed dispersion equations are verified through agreement with the full-wave simulation results. It is experimentally demonstrated that the proposed VSI-EBG structure for differential signaling suppresses the CM noise in the wideband frequency range without degrading the differential characteristics.
منابع مشابه
Partial EBG Structure with DeCap for Ultra - wideband Suppression of Simultaneous Switching Noise in a High - Speed System
© 2010 Jong Hwa Kwon et al. 265 To supply a power distribution network with stable power in a high-speed mixed mode system, simultaneous switching noise caused at the multilayer PCB and package structures needs to be sufficiently suppressed. The uniplanar compact electromagnetic bandgap (UC-EBG) structure is well known as a promising solution to suppress the power noise and isolate noise-sensit...
متن کاملCommon-Mode Suppression Design for Gigahertz Differential Signals Based on C-Slotline
For wideband common-mode noise suppression in high-speed differential signals, a low-cost compact filter is proposed and designed by etching two coupled C-slotlines on the ground plane. It is found that the bandwidth of the common-mode stopband over −10 dB is from 2.4GHz to 6.35GHz with no degradation of the differential-mode insertion loss and group delay within the wide common-mode stopband. ...
متن کاملA High Gain and Forward Body Biastwo-stage Ultra-wideband Low Noise Amplifier with Inductive Feedback in 180 nm CMOS Process
This paper presents a two-stage low-noise ultra-wideband amplifier to obtain high and smooth gain in 180nm CMOS Technology. The proposed structure has two common source stages with inductive feedback. First stage is designed about 3GHz frequency and second stage is designed about 8GHz. In simulation, symmetric inductors of TSMC 0.18um CMOS technology in ADS software is used.Simulations results ...
متن کاملA Low Power Low Voltage Rail to Rail Constant gm Differential Amplifier with 150 dB CMRR and Enhanced Frequency Performance
This paper proposes a low voltage (±0.55V supply voltage) low power (44.65µW) high common mode rejection ratio (CMRR) differential amplifier (d.a.) with rail to rail input common mode range (ICMR), constant transconductance (gm) and enhanced frequency performance. Its high performance is obtained using a simple negative averaging method so that it cancels out the common mode input signals at th...
متن کاملCurved uniplanar EBG structure for suppressed ground bounce noise and improved signal integrity in power planes
A novel wideband uniplanar electromagnetic bandgap structure with curved line bridges (C-EBG) is proposed to be used in power planes for suppressed ground bounce noise (GBN) and improved signal integrity. Compared with a conventional uniplanar electromagnetic bandgap structure with straight line bridges (S-EBG), the CEBG structure significantly increases the equivalent inductance with less spli...
متن کامل