Contact stiffness of randomly rough surfaces
نویسندگان
چکیده
We investigate the contact stiffness of an elastic half-space and a rigid indenter with randomly rough surface having a power spectrum C2D(q)proportional q(-2H-2), where q is the wave vector. The range of H[symbol: see text] is studied covering a wide range of roughness types from white noise to smooth single asperities. At low forces, the contact stiffness is in all cases a power law function of the normal force with an exponent α. For H > 2, the simple Hertzian behavior is observed . In the range of 0 < H < 2, the Pohrt-Popov behavior is valid (). For H < 0, a power law with a constant power of approximately 0.9 is observed, while the exact value depends on the number of modes used to produce the rough surface. Interpretation of the three regions is given both in the frame of the three dimensional contact mechanics and the method of dimensionality reduction (MDR). The influence of the long wavelength roll-off is investigated and discussed.
منابع مشابه
Partial-slip frictional response of rough surfaces
If two elastic bodies with rough surfaces are first pressed against each other and then loaded tangentially, sliding will occur at the boundary of the contact area while the inner parts may still stick. With increasing tangential force, the sliding parts will expand while the sticking parts shrink and finally vanish. In this paper, we study the fractions of the contact area, tangential force an...
متن کاملMeasurement and Modeling of Normal Contact Stiffness and Contact Damping at the Meso Scale
Modeling of contact interfaces that inherently include roughness such as joints, clamping devices, and robotic contacts, is very important in many engineering applications. Accurate modeling of such devices requires knowledge of contact parameters such as contact stiffness and contact damping, which are not readily available. In this paper, an experimental method based on contact resonance is d...
متن کاملHomogenization for contact problems with periodically rough surfaces
We consider the contact of two elastic bodies with rough surfaces at the interface. The size of the micro-peaks and -valleys is very small compared with the macrosize of the bodies’ domains. This makes the direct application of the FEM for the calculation of the contact problem prohibitively costly. A method is developed that allows deriving a macrocontact condition on the interface. The method...
متن کاملMultiscale Modeling of Stiffness, Friction and Adhesion in Mechanical Contacts
U O Q U A N T Fraction of surface atoms in contact, A /A f i c Friction proportional to Ac and Ac proportional to load L for rough surfaces Flat surfaces in complete contact at any load Molecular Simulations Differ on Applicability of Macroscopic Results at Atomic Scales friction and adhesion in macroscopic models Results for flat surfaces can be mapped directly to other geometries usi...
متن کاملStiffness of contacts between rough surfaces.
The effect of self-affine roughness on solid contact is examined with molecular dynamics and continuum calculations. The contact area and normal stiffness rise linearly with the applied load, and the load rises exponentially with decreasing separation between surfaces. Results for a wide range of roughness, system size, and Poisson ratio can be collapsed using Persson's contact theory for conti...
متن کامل