The adhesion between prefabricated FRC posts and composite resin cores: microtensile bond strength with and without post-silanization.

OBJECTIVES Aim of the study was to measure the adhesion between two types of translucent prefabricated FRC posts (FRC Postec, Ivoclar-Vivadent, FRC; Light-Post, RTD, LP), and two types of flowable composites used as core materials (UnifilFlow, GC, UF; Tetric Flow, Ivoclar-Vivadent, TF), with or without the application of a silane (Monobond-S, Ivoclar-Vivadent, S) on the post surface. METHODS The experimental groups were: 1.1 FRC+UF; 1.2 FRC+S+UF; 1.3 FRC+TF; 1.4 FRC+S+TF: 2.1 LP+UF; 2.2 LP+S+UF; 2.3 LP+TF; 1.4 LP+S+TF. The bond strength at the interface between post and core was measured with the microtensile non-trimming technique. Thirty to thirty-five beam-shaped specimens per group were obtained from cylinders of core material, which had been built up around the post by progressively adding small increments of composite resin. Each specimen was loaded in tension until failure at either one of the two post-core interfaces present in each stick. The differences in interfacial bond strength among the groups were tested for statistical significance with the two-way ANOVA. RESULTS The measured bond strengths in MPa were: [table: see text]. The statistical analysis revealed that post-silanization had a significant effect on adhesion (p<0.05). With any combination of post and core materials tested, the application of a silane onto the post surface prior to building up the core significantly increased the post-core bond strength. SIGNIFICANCE For improved adhesion at the interface between prefabricated FRC posts and composite resin cores, post-silanization is advisable.