Properties of SnS thin films grown by physical vapour deposition

نویسندگان

  • M Ganchev
  • P Vitanov
  • M Sendova-Vassileva
  • G Popkirov
  • H Dikov
چکیده

Thin films of tin sulfide (SnS) were prepared by thermal evaporation technique on glass substrates and on n-type Si substrate and their physical properties were studied. The phase of the obtained thin films before and after thermal treatment was confirmed by X-ray diffraction analysis and Raman spectra. Optical transmission and reflection spectra were measured in the wavelength range 300-1800 nm, and the data were used to determine the direct and indirect optical band gaps. Four-point measurements have revealed that SnS thin film exhibits p-type conduction. Current-voltage characteristics of the SnS/ n-Si structures demonstrate strong photosensitivity and photovoltaic effect. However, in order to be able to evaluate the potential applicability of this heterojunction for photovoltaic or electronic devices, further study and technological optimization has to be conducted.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Preparation and growth of SnS thin film deposited by spray pyrolysis technique

In  this paper  thin  films of  tin sulfide (SnS) were deposited on  the glass substrates using spray pyrolysis method with the substrate temperatures in the range of 400–600℃, keeping the other deposition parameters constant. In  this work  the characteristic of SnS  thin  films  investigated. The XRD pattern and optical transmittance of thin films also are discussed. With the change in concen...

متن کامل

Synthesis of Boron-Aluminum Nitride Thin Film by Chemical Vapour Deposition Using Gas Bubbler

Boron included aluminium nitride (B-AlN) thin films were synthesized on silicon (Si) substrates through chemical vapour deposition ( CVD ) at 773 K (500 °C). tert-buthylamine (tBuNH2) solution was used as nitrogen source and delivered through gas bubbler. B-AlN thin films were prepared on Si-100 substrates by varying gas mixture ratio of three precursors. The structural properties of the films ...

متن کامل

Thermal Annealing Influence over Optical Properties of Thermally Evaporated SnS/CdS Bilayer Thin Films

Thin films of tin sulfide/cadmium sulfide (SnS/CdS) were prepared bythermal evaporation method at room temperature on a glass substrate and then annealedat different temperature with the aim of optimizing the optical properties of the materialfor use in photovoltaic solar cell devices. The effect of annealing on optical propertiesof SnS/CdS film was studied in the temper...

متن کامل

Enhanced Physical Properties Of Indium Tin Oxide Films Grown on Zinc Oxide-Coated Substrates

Structural, electrical and optical properties of indium tin oxide or ITO (In2O3:SnO2) thin films on different substrates are investigated. A 100-nm-thick pre-deposited zinc oxide (ZnO) buffer layer is utilized to simultaneously improve the electrical and optical properties of ITO films. High purity ZnO and ITO layers are deposited with a radio frequency sputtering in argon ambient with plasma p...

متن کامل

Synthesis of carbon nano structures on Fe/Cu/AI and Al/Steel by thermal chemical vapour deposition method

Using C2H2, 112 and As gases at 550'C, carbon nanotubes were fabricated on the surfaces of twosubstrates coated by nano thin layers of metal catalysts by DC magnetron sputtering. AYStamless steel andFe/CteAl, by thermal chemical vapor deposition (TCVD) The surface properties of the substrates wereparticularly investigated, and the effect of treatment of the substrates on the CNT's growth is cri...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2015