Rheology and melt characterization of low-fat and full fat Mozzarella cheese made from microfluidized milk

Microfluidization of cheese milk at different temperatures and pressures altered the meltability and rheological properties of Mozzarella cheese. Pasteurized milks, standardized to 1.0 (low-fat (LF)) or 3.2 (full fat (FF)) g fat/100 g milk, heated to 10, 43, or 54 1C, and then microfluidized at pressures of 34, 103, or 172MPa, were used to manufacture Mozzarella cheese. Cheeses made from nonmicrofluidized milks served as controls. During the hot water step, only control cheeses and cheeses made with milk microfluidized at 10 1C could be stretched while all others had short curds that did not fuse together. Cheese responses to different stresses (heat, compression, torsion, and oscillatory shear) were measured after 1 and 6weeks of storage. FF cheeses made with the control milks and milks processed at 10 1C/34MPa or 10 1C/103MPa were softer and less rigid, and had the lowest visco-elastic properties and the highest meltabilities of all the cheeses. Microfluidization of the cheese milk did not improve the melt or rheology of LF cheeses. Microfluidization of milk with fat in the liquid state at higher pressures resulted in smaller lipid droplets that altered the component interactions during the formation of the cheese matrix and resulted in LF and FF Mozzarella cheeses with poor melt and altered rheology. Published by Elsevier Ltd. on behalf of Swiss Society of Food Science and Technology.