In vitro dissolution enhancement of micronized l-nimodipine by antisolvent re-crystallization from its crystal form H.
نویسندگان
چکیده
In order to enhance solubility and dissolution rate in water, micronized l-nimodipine (NMD) has been successfully prepared by antisolvent re-crystallization process using acetone as solvent and deionized water as antisolvent. The effects of five experimental parameters on the mean particle size (MPS) of NMD nanosuspension were investigated. It was found that the MPS of NMD nanosuspension decreased significantly when the concentration of NMD-acetone solution increased from 50 to 150 mg/mL along with the increase of volume ratio of antisolvent to solvent from 1 to 3, and then increased slightly with the following increase of them. By contrast, the MPS decreased with the increased feed rate of NMD-acetone solution and the amount of surfactant, from 1 to 3 mL/min and 0.025% to 0.2%, respectively. Thereafter, the MPS did not show any obvious change. The precipitation temperature had no significant effects on MPS. The optimum micronization conditions were determined as follows: NMD-acetone solution concentration of 150 mg/mL, the volume ratio of antisolvent to solvent of 3, the flow rate of NMD-acetone solution of 9 mL/min, the preparation temperature of 15°C and the amount of the surfactant of 0.2%. Under optimum conditions, micronized NMD with a MPS of 708.3 nm was obtained. The micronized product was characterized using scanning electron microscopy (SEM), Fourier transform infrared spectroscopy (FTIR), high performance liquid chromatography-mass spectrometry (LC-MS), X-ray diffraction (XRD), differential scanning calorimetry (DSC), and thermo gravimetric (TG), to verify the influences of micronization process on the final product. The results showed that the chemical structure of micronized NMD was not changed, but the crystalline structure had undergone transition during precipitation, which changed from form H into L. The dissolution test showed that micronized NMD exhibited enhanced dissolution rate and solubility of 5.22 folds compared to raw H-NMD. These results suggested that micronized NMD may have potential value to become a new oral NMD formulation with high bioavailability.
منابع مشابه
Physicochemical Properties and In Vitro Dissolution of Spiramycin Microparticles Using the Homogenate-Antisolvent Precipitation Process
Due to its low bioavailability and slow dissolution rate, the micronized spiramycin powder was thus prepared by the homogenate-antisolvent precipitation (HAP) process. The optimum micronization conditions of the HAP process were found to be as follows: precipitation temperature of 4.6 ◦C, precipitation time of 10 min, spiramycin concentration of 20 mg/mL, dripping speed of the added solvent int...
متن کاملDrug Release Studies of Naproxen Agglomerates Produced by the Antisolvent Approach in the Presence of Hydroxypropyl Cellulose
In this study, the effect of recrystallization of naproxen in the presence of hydroxypropyl cellulose (HPC) on the release rate of drug was investigated. Crystals were generated by the anti-solvent approach using the HPC solution in water as the anti-solvent. The samples were subjected to various physicochemical evaluations such as crystal size, scanning electron microscopy, Fourier tran...
متن کاملEnhanced production of unstable polymorph by antisolvent crystallization supplying minute-bubbles
Differences in physical and chemical properties between polymorphic compounds (e.g. solubility, dissolution rate, chemical reactivity, resistance to degradation, bioavailability) are highly significant for the pharmaceutical industry, which requires effective methods to control polymorphism of organic crystals [1, 2]. In particular, to improve the functionality such as solubility or bioavailabi...
متن کاملFormulation and Solid State Characterization of Nicotinamide-based Co-crystals of Fenofibrate
The present investigation deals with formulation of nicotinamide-based co-crystals of fenofibrate by different methods and solid-state characterization of the prepared co-crystals. Fenofibrate and nicotinamide as a coformer in 1:1 molar ratio were used to formulate molecular complexes by kneading, solution crystallization, antisolvent addition and solvent drop grinding methods. The prepared mol...
متن کاملDeveloping a Systematic Design Approach to Tailor Crystal Size Distribution for Mixing-Sensitive Crystallization Processes
The design of crystallization processes becomes more complicated when mixing affects the final crystal product quality (e.g., crystal size distribution and polymorphic form). Such mixing effects are more apparent in antisolvent and reactive crystallizations, which involve the blending of different fluids, and in large-scale crystallizers, where homogeneity cannot be easily achieved. In this pap...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
- International journal of pharmaceutics
دوره 464 1-2 شماره
صفحات -
تاریخ انتشار 2014