Analysis of Thermal Stresses around a Cryosurgical Probe

نویسندگان

  • Rabin
  • Steif
چکیده

Large thermal stresses easily exceeding the tissue yield strength may develop in the frozen region around a cryosurgical probe. A new integrodifferential solution for the heat transfer problem of biological tissues freezing around a cryosurgical probe is presented in this article. This solution is suitable for cases of high Stephan numbers and for a temperature-dependent forcing function at the cryoprobe. A new solution for the thermal stresses around a cryosurgical probe is also presented, based on an elastic-perfectly plastic model. It is proposed that thermal stresses beyond the elastic limit of the frozen region may sharply increase the mechanical damage to the cell membranes due to plastic deformation. It was found that plastic deformation always starts at the cryoprobe surface; however, plastic deformation may also be formed near the freezing front at high cooling rates and large cryoprobes. It is demonstrated that under some conditions plastic deformation may occur in the entire frozen region. A parametric study to identify the best cooling protocol for maximal plastic deformation is presented.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Gel phantom study of a cryosurgical probe with a thermosiphon effect and liquid nitrogen-cooled aluminum thermal storage blocks

Cryosurgery is a minimally invasive treatment for certain types of cancers. Argon-based cryosurgical devices are available at present, however a large compressed gas cylinder with the pressure of 300 atmospheres is needed. To overcome these drawbacks, we developed a new cryosurgical probe measuring about 50 cm in length with separate lumens inside for liquid and gaseous ethylene to be used as a...

متن کامل

Analysis of Thermal-Bending Stresses in a Simply Supported Annular Sector Plate

The present article deals with the analysis of thermal-bending stresses in a heated thin annular sector plate with simply supported boundary condition under transient temperature distribution using Berger’s approximate methods. The sectional heat supply is on the top face of the plate whereas the bottom face is kept at zero temperature. In this study, the solution of heat conduction is obtained...

متن کامل

Investigation and zoning of thermal physiological stresses in Iran

Analysis and zoning of thermal physiological stresses in Iran   Abstract Human health is influenced by weather variables in all circumstances, including atmospheric pressure, humidity and temperature around them. Based on climate hazard and climate changes, different parts of human life and economic and social strategies such as health, hydrological pollutants And agriculture had a profound ...

متن کامل

Micromachined Heat Exchanger for a Cryosurgical Probe

This paper describes a lithography-based microfabrication process developed for a recuperative heat exchanger intended for use in a cryosurgical probe. The probe, which uses the Joule-Thomson (JT) cooling cycle, must achieve a temperature < -50°C, with a freeze rate of 25-50°C/min. The heat exchanger must maintain high stream-to-stream thermal conductance while restricting parasitic stream-wise...

متن کامل

Transient Thermal Stresses Analysis in a FPGM Cylinder

The present study aims to investigate the analysis of stress, strain, displacement, and electrical potential of a thick hollow cylinder made of FGPM under mechanical and thermal loads. Distribution of mechanical property of material is considered along the shell stick through the power distribution function. Thermal loads have been taken to signify the difference of temperature between outer an...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • Cryobiology

دوره 33 2  شماره 

صفحات  -

تاریخ انتشار 1996