Control Reconfiguration
نویسنده
چکیده
This chapter explains methods for the automatic selection of a new control configuration after some fault has changed the dynamical properties of the plant. An automatic control system can use this method after severe faults have been detected in the plant by a monitoring algorithm. It chooses new actuators, new sensors, a new control law and possibly new set-points so as to stabilize the plant in the prescribed operation point under the influence of the fault.
منابع مشابه
Control Reconfiguration of a Boiler-Turbine Unit After Actuator Faults
Boiler-turbines are one of the most important parts in power generation plants. The safety problem in such systems has always been a special concern. This paper discusses the application of control reconfig uration by fault-hiding approach for a boiler-turbine unit. In Fault-hiding approach, after occurrence of a fault, nominal controller of the system remains unchanged; instead, a reconfigurat...
متن کاملReconfiguration and optimal placement of distributed generations in distribution networks in the presence of remote voltage controlled bus using exchange market algorithm
Abstract: Since distribution networks have a large share of the losses in power systems, reducing losses in these networks is one of the key issues in reducing the costs of global networks, including issues Which has always been considered. In this thesis, the reconfiguration of the distribution network in the presence of distributed generation sources (DGs) with respect to two types of bus, P ...
متن کاملEconomic Evaluation of Optimal Capacitor Placement in Reconfiguration Distribution System Using Genetic Algorithm
Optimal capacitor placement, considering power system loss reduction, voltage profile improvement, line reactive power decrease and power factor correction, is of particular importance in power system planning and control. The distribution system operator calculates the optimal place, number and capacity of capacitors based on two major purposes: active power loss reduction and return on invest...
متن کاملControl Reconfiguration: Survey of Methods and Open Problems
This report surveys recent results and approaches from the field of control reconfiguration within a general fault-tolerant control framework. Open problems for future research are identified. Control reconfiguration is embedded within a wider fault-tolerant control context and set apart from other approaches to achieve fault tolerance. It is explained why simpler approaches than control reconf...
متن کاملRobust control reconfiguration of resource allocation systems with Petri nets and integer programming
Supervisory control reconfiguration can handle the uncertainties including resource failures and task changes in discrete event systems. It was not addressed to exploit the robustness of closed-loop systems to accommodate some uncertainties in the prior studies. Such exploitation can cost-efficiently achieve reconfigurability and flexibility for real systems. This paper presents a robust reconf...
متن کاملModelling Vector Control System Reconfiguration
To apply run-time reconfiguration there is need for an appropriate model to understand reconfiguration. System on chip technology allowed the use of complex low gate/price new type of FPGA. Modelling reconfiguration and using Matlab tools is possible to simulate and rapid prototype vector control systems. The paper presents the reconfigurable models as introduced by Luk, Cheung, Shirazi and Ath...
متن کامل