Control of Time-varying Lateral Tape Motion in a Linear-tape-open Drive via Adaptive Regulation
نویسندگان
چکیده
Introduction This extended abstract summarizes a methodology along with the experimental results to adaptively reduce timevarying lateral tape motion (LTM) in a Linear Tape-Open (LTO) drive. For the adaptive regulation, the LTO actuator dynamics is modeled with a Linear Time Invariant (LTI) model and control of time-varying LTM disturbances is done via an adaptable linear feedback controller. Adaptive regulation is done via the direct estimation of a perturbation on the feedback controller. By simultaneously minimizing the variance of the Position Error Signal (PES) and the control output signal, the direct estimation of the controller perturbation is formulated as a weighted estimation problem that is implemented recursively for real-time implementation. The experimental results show a significant reduction of the variance of the PES over different tape cartridges and a constant PES variance during a complete reelin/out operation of the tape drive.
منابع مشابه
Adaptive Regulation of Time Varying Disturbances in a Tape Storage System
Archival demands for digital tape storage systems require smaller spacing between data tracks on the magnetic tape to allow for more data storage on a single cartridge. Increasing track density while maintaining track following provides a challenge for the servo control of the tape drive. In particular, interchangeable tape cartridges and time-varying tape reel diameters during operation cause ...
متن کاملCharacterization of lateral tape motion and disturbances in the servo position error signal of a linear tape drive
Lateral tape displacement in a tape drive is believed to be one of the critical limiting factors in achieving high track density in tape storage media. For improving track density, servo control systems can be designed on the basis of information from a position error signal to improve the track following capabilities in a tape drive. In this paper, we consider the characterization of lateral t...
متن کاملModeling and Control of Lateral Tape Motion for Improved Performance
Introduction The current state of the art for controlling lateral tape motion is a well tuned PID controller that is able to reject all low frequent disturbances. In this paper, we seek to improve this control design by modeling the source of the disturbances in lateral tape motion LTM and designing a controller to reject these specific disturbances instead of all low frequent disturbances. Thi...
متن کاملCorrelation of Lateral Tape Motion and Tape Tension Transients
Introduction High frequency lateral tape motion (LTM) is a problem in tape technology that limits track density in a tape drive. To reduce high frequency LTM, it is important to identify all sources of lateral tape motion. The most important sources of high frequency LTM are edge contact between tape and tape drive components, non-repeatable roller axial run-out, air induced flutter and tape te...
متن کاملBart Raeymaekers ASME / JSME Joint Conference on Micromechatronics for Information and Precision Equipment ( MIPE
Introduction Lateral tape motion (LTM) is the time-dependent displacement of magnetic tape perpendicular to the tape transport direction. Lateral tape motion may cause track misregistration between the read/write head and a previously written track, thereby limiting the recording density that can be achieved [1]. Currently, the track density of typical magnetic tape drives is approximately 40 t...
متن کامل