A Geometric Model for Fatigue Crack Closure Induced by Fracture Surface Roughness
نویسنده
چکیده
Mechanisms for fatigue crack closure under plane strain conditions have recently been identified at very low (near-threshold) stress intensities in terms of effects of excess corrosion deposits or fracture surface roughness in promoting premature closure of the crack. In the present paper, a geometric model is presented for crack closure induced by fracture surface roughness. This model specifically addresses the contribution from both Mode I and Mode II crack tip displacements in addition to considering the nature of the fracture surface morphology. The implications of this model are briefly discussed in light of the roles of grain size, yield strength, microstructure, and crack size in influencing near-threshold fatigue behavior in engineering alloys.
منابع مشابه
Fatigue crack closure: a review of the physical phenomena
Plasticity-induced, roughness-induced and oxide-induced crack closures are reviewed. Special attention is devoted to the physical origin, the consequences for the experimental determination and the prediction of the effective crack driving force for fatigue crack propagation. Plasticity-induced crack closure under plane stress and plane strain conditions require, in principle, a different expla...
متن کاملA fatigue crack initiation model incorporating discrete dislocation plasticity and surface roughness
Although a thorough understanding of fatigue crack initiation is lacking, experiments have shown that the evolution of distinct dislocation distributions and surface roughness are key ingredients. In the present study we introduce a computational framework that ties together dislocation dynamics, the fields due to crystallographic surface steps and cohesive surfaces to model near-atomic separat...
متن کاملFATIGUE BEHAVIOUR OFA ROLLED AZ31 MAGNESIUM ALLOYS PREPARED BY EPAND BB CONDITIONS
Abstract: Rotating bending fatigue tests have been performed using smooth specimens of a rolled AZ31 magnesium alloy in laboratory air at ambient temperature. Fatigue strength and characteristic was evaluated and fracture mechanism was discussed on the basis fracture surface analysis. Electrical polishing (EP) as well as deep rolling (ball burnishing (BB)) U-notched specimens were performed on ...
متن کاملFatigue Behaviour in Fine Grained Aluminium Alloys
The effects of alloy production method on microstructure and hence fatigue crack growth rate and fracture mechanism have been examined for a variety of fine-grained/high dispersoid Al-Li-Mg-Zr and Al-Li-Cu-Mg-Zr alloys. Microstructures have been assessed by scanning and transmission electron microcopy, together with electron back scattered diffraction pattern assessment. In these fine-grained/h...
متن کاملHigh frequency fatigue crack propagation behavior of a nickel-base turbine disk alloy
Fatigue crack propagation tests were conducted on the powder metallurgy nickel-base superalloy KM4 at room temperature. Two different heat treatments were investigated, one which produced a relatively coarse grain size around 55 μm, and another which produced a very fine grain size around 6 μm. Tests were conducted at 50 Hz and 1000 Hz in an advanced servohydraulic testing machine at R-ratios b...
متن کامل