Technology of WAVE and Feature Cutter volume of manufacturing
نویسندگان
چکیده
A forward and automatic method for in-process model generation is proposed and integrated with three-dimensional computer aided process planning (CAPP) system. The method based on feature cutter volume of manufacturing drives the in-process model to evolve from blank to part, which is coincident with the manufacturing process and ideology of process design. At the same time, technology of What-if Alternative Value Engineering (WAVE) is implanted in the generation to establish the relationship of in-process models, which supports function of the automatic update for models. The paper introduces a theory of the solution to demonstrate the connection between manufacture feature and feature cutter volume, and detailedly presents the technological process in applying the WAVE technology. Examples are completed in a commercial CAPP system to illustrate the feasibility of this approach.
منابع مشابه
Design and Manufacture of a Smart Orthopedic Pin Cutter for Use in the Operating Room and Patients Undergoing Orthopedic Surgery
Background and Aim: Since pin cutter is used in surgical operations involving screw and orthopedic plating and this is one of the most sensitive surgeries, saving time is very important along with reducing infection rate. The purpose of design the Mini-Pin Cutter is to replace a smaller, lighter, more efficient device than conventional and traditional cutters, which ultimately results in a comf...
متن کاملDetermination the Mechanical Stress on the Cutter Bar of the Harvesting Combine by Abaqus
In this paper, to simulate mechanical stress on the cutter bar of the harvesting combine during cutting of wheat stems, first, shearing strength of the stems was measured for various moisture content levels and cutting heights. After that the cutter bar of combine was simulated by Abaqus with the specified conditions. The results of the simulation showed that with increase in moisture content o...
متن کاملDetermination the Mechanical Stress on the Cutter Bar of the Harvesting Combine by Abaqus
In this paper, to simulate mechanical stress on the cutter bar of the harvesting combine during cutting of wheat stems, first, shearing strength of the stems was measured for various moisture content levels and cutting heights. After that the cutter bar of combine was simulated by Abaqus with the specified conditions. The results of the simulation showed that with increase in moisture content o...
متن کاملEnergy Resources Consumption Performance in Iranian Manufacturing Industries by Using Cost/Revenue Efficiency Model
Industries are one of the main sources of pollution in the world. Besides, the levels of energy resources consumption including water, electricity, and fossil fuel are very different among industries. On the other hand, Iranian government pays a large amount of energy subsidy to manufacturing units. Because of it, the government wants to know which of manufacturing industries are efficient, pro...
متن کاملDevelopment of Design and Manufacturing Support Tool for Optimization of Ultrasonic Machining (USM) and Rotary USM
Ultrasonic machining (USM) is a mechanical material removal process used to erode holes and cavities in hard or brittle work pieces by using shaped tools, high-frequency and an abrasive slurry. This paper addresses the concept and development of an expert system (ES) for hard and brittle material, such as glass, quartz, diamond, carbides, semi conducting materials, ceramic and graphite which ca...
متن کامل