Optical PreAmplifier (TIA) Design for High Speed Optical Communication with Optimized Performance
نویسنده
چکیده
In this paper, the bandwidth enhancement of TIA amplifier can be design for achieving the high information capacity which is used in optical fiber communication for existing transimpedance amplifiers in CMOS technology. The proposed TIA amplifier also trade-offs between gain, bandwidth, noise, and group delay variation with introduce on differential architecture along an RGC network as input and incorporating a feedback network and peaking inductors for bandwidth enhancement. The capacitive degeneration is also introduced to increase the number of zeros for better phase performance.
منابع مشابه
Transimpedance Amplifier (TIA) Design for 400 Gb/s Optical Fiber Communications
(ABSTRACT) Analogcircuit/IC design for high speed optical fiber communication is a fairly new research area in Dr. Ha's group. In the first project sponsored by ETRI (Electronics and Telecommunication Research Institute) we started to design the building blocks of receiver for next generation 400 Gb/s optical fiber communication. In this thesis research a transceiver architecture based on 4x100...
متن کاملInvestigations on Receiver sensitivity of 10 Gbps SOA based optical communication system
In this paper, investigations are done for performance improvement of optimized SOA preamplifier [13] for 32, 64 channels and various channel spacing. The effects of number of channels and channel spacing are analyzed in terms of receiver sensitivity of the optimized preamplifier based optical receiver. General Terms: Pre-amplifier
متن کاملDesign of Arrayed Waveguide Grating based Optical Switch for High Speed Optical Networks
This paper demonstrates the design of an Arrayed Waveguide Gratings (AWG) based optical switch. In the design both physical and network layer analysis is performed. The physical layer power and noise analysis is done to obtain Bit Error Rate (BER). This has been found that at the higher bit rates, BER is not affected with number of buffer modules. Network layer analysis is done to obtain perfor...
متن کاملA 25Gb/s 170μW/Gb/s Optical Receiver in 28nm CMOS for Chip-to-Chip Optical Communication
A low-power high-speed optical receiver in 28nm CMOS is presented. The design features a novel architecture combining a low-bandwidth TIA front-end, double-sampling technique and dynamic offset modulation. The low-bandwidth TIA increases receiver’s sensitivity while adding minimal power overhead. Functionality of the receiver was validated and the design is compared with a conventional 3-stage ...
متن کاملOptimized Design of Nanohole Array-Based Plasmonic Color Filters Integrating Genetic Algorithm with FDTD Solutions
Recently, significant interest has been attracted by the potential use of aluminum nanostructures as plasmonic color filters to be great alternatives to the commercial color filters based on dye films or pigments. These color filters offer potential applications in LCDs, LEDs, color printing, CMOS image sensors, and multispectral imaging. However, engineering the optical characteristics of thes...
متن کامل