Influence of the Inlet Conditions on the Degree of Mixing of a T-shaped Micro-mixer
ثبت نشده
چکیده
The degree of mixing of a T-shaped micro-mixer depends strongly on the inlet flow conditions. Specifically, through a series of numerical simulations, we compared the case where the flow at the micro-mixer confluence is fully developed with that when it is not, and found that in the former case engulfment occurs at smaller Reynolds number, with a different flow pattern and with much larger mixing efficiencies than in the latter case. In particular for fully developed flow conditions the engulfment shows S-shaped morphology, whereas for nonfully developed inlets a symmetry breaking occurs, leading to a C-shaped engulfment pattern. This is characterized by much lower mixing efficiencies.
منابع مشابه
Rapid mixing of Newtonian and non-Newtonian fluids in a three-dimensional micro-mixer using non-uniform magnetic field
The mixing of Newtonian and non-Newtonian fluids in a magnetic micro-mixer was studied numerically using ferrofluid. The mixing process was performed in a three-dimensional steady-state micro-mixer. A magnetic source was mounted at the entrance of the micro-channel to oscillate the magnetic particles. The effects of electric current, inlet velocity, size of magnetic particles, and non-Newtonia...
متن کاملGas Mixing Simulation in a T-Shape Micro Channel Using The DSMC Method
Gas mixing in a T-shape micro mixer has been simulated using the Direct Simulation Monte Carlo (DSMC) method. It is considered that the adequate mixing occurs when the mass composition of the species, CO or N2, deviates below 1 % from their equilibrium composition. The mixing coefficient is defined as the ratio of the mixing length to the main channel’s height. As the inlet Kn increases, while ...
متن کاملThe effect of flow parameters on mixing degree of a three dimensional rhombus micromixer with obstacles in the middle of the mixing channel using oscillatory inlet velocities
The previous studies of authors on passive micromixers indicated that the micromixers dividing the flow to several layers, such as rhombus micromixers and micromixers with obstacles in the middle of the mixing channel, have higher mixing degree than other types. Also, using of oscillatory inlet velocities is an active method to enhance the mixing efficiency of micromixers. Therefore, in this st...
متن کاملNumerical Study on Low Reynolds Mixing ofT-Shaped Micro-Mixers with Obstacles
Micromixers are one of the most crucial components of Lab-On-a-Chip devices with the intention of mixing and dispersion of reagents like small molecules and particles. The challenge facing micromixers is typically insufficient mixing efficiency in basic designs, which results in longer microchannels. Therefore, it is desirable to increase mixing efficiency, in order to decrease mixing length, w...
متن کاملInvestigating Fluid Mixing in Electro-Osmotic Flow Through Passive Micro-Mixers Having Square and Triangle Barriers
Objective: In this article, a numerical study is conducted on mixing of two fluids in the liquid phase with two different concentrations of a chemical species in the electro-osmotic flow. Methods: The base liquid is an electrolyte which flows in a two-dimensional micro-channel having electrically charged walls. Lorentz electric force, which is used as stimulating flow factor, is created by appl...
متن کامل