A Viscoelastic Model for the Rate Effect in Transfer Printing
نویسندگان
چکیده
Transfer printing is a volatile tool to retract micro devices from a donor substrate via elastomeric stamps, from which the devices are grown or fabricated, followed by printing to a receiver substrate where the device is assembled to an array for integration in various applications. Among the five approaches of transfer printing summarized in the paper, the viscoelastic property of stamps is widely adopted to modulate the interfacial adhesion between the stamp and devices by applying different pulling speeds. A viscoelastic model for transfer printing is analytically established. It shows that the interfacial adhesion increases with pulling speed, which is verified by the experiments and numerical simulations. [DOI: 10.1115/1.4007851]
منابع مشابه
Forced Convection Heat Transfer of Giesekus Viscoelastic Fluid in Concentric Annulus with both Cylinders Rotation
A theoretical solution is presented for the forced convection heat transfer of a viscoelastic fluid obeying the Giesekus constitutive equation in a concentric annulus under steady state, laminar, and purely tangential flow. A relative rotational motion exists between the inner and the outer cylinders, which induces the flow. A constant temperature was set in both cylinders, in this study. The f...
متن کاملSemi-Analytical Solution for Vibration of Nonlocal Piezoelectric Kirchhoff Plates Resting on Viscoelastic Foundation
Semi-analytical solutions for vibration analysis of nonlocal piezoelectric Kirchhoff plates resting on viscoelastic foundation with arbitrary boundary conditions are derived by developing Galerkin strip distributed transfer function method. Based on the nonlocal elasticity theory for piezoelectric materials and Hamilton's principle, the governing equations of motion and boundary conditions are ...
متن کاملViscoelastic Micropolar Convection Flows from an Inclined Plane with Nonlinear Temperature: A Numerical Study
An analytical model is developed to study the viscoelastic micropolar fluid convection from an inclined plate as a simulation of electro-conductive polymer materials processing with nonlinear temperature. Jeffery’s viscoelastic model is deployed to describe the non-Newtonian characteristics of the fluid and provides a good approximation for polymers. Micro-structural is one of the characteristi...
متن کاملCalculation of tunnel behavior in viscoelastic rock mass
Wall displacements and ground pressure acting on the lining of a tunnel increase with time. These time-dependent deformations are both due to face advance effect and to the time-dependent behavior of the rock mass. Viscoelastic materials exhibit both viscous and elastic behaviors. Thorough this study, the effect of different linear viscoelastic models including Maxwell, Kelvin and Kelvin-Voigt...
متن کاملMechanical Simulation of the Extension and Flexion of the Elbow Joint in Rehabilitation
Objective: The goal of the present study was to improve the extension and flexion of the elbow joint for rehabilitation purposes, in terms of energy dissipation and of injuries caused by stress imposed on connective tissue by exercise equipments during force transfer , by investigation of viscoelastic property variations during change in speed of motion. Materials & Methods: A sample of five...
متن کامل