Recrystallization Behavior of Commercial Purity Aluminium Alloys
نویسنده
چکیده
منابع مشابه
The Investigation of Modelling Material Behavior in Autofrettaged Tubes Made from Aluminium Alloys
Normal 0 false false false EN-US X-NONE AR-SA The ratio of compression yield strength to the initial tensile yield strength is called Bauschinger effect factor, BEF. A nonlinear strain hardening mathematical model is proposed for 7075 aluminium alloy (A7075). Uniaxial tension-compression experimental data are used to figure out a suitable model to study the BEF. Hence, uniaxial tension-co...
متن کاملEvolution of microstructure and precipitation in heat-treatable aluminium alloys during ECA pressing and subsequent heat treatment
The precipitation and evolution of microstructure in a spray-cast Al-7034 alloy and a commercial wrought Al-2024 alloy were studied after equal-channel angular pressing (ECAP) using transmission electron microscopy and differential scanning calorimetry (DSC). Microstructural examination showed the grain sizes of both alloys were reduced to the range of ~0.3–0.5 μm through ECAP. The DSC analysis...
متن کاملFRACTIONAL RECRYSTALLIZATION KINETICS IN DIRECTLY COLD ROLLED Al-Mg, Al-Mg-Sc AND Al-Mg-Sc-Zr ALLOY
The evaluation of texture as a function of recrystallization has been characterized for directly cold rolled Al-6Mg, Al-6Mg-0.4Sc and Al-6Mg-0.4Sc-0.2Zr alloys. Samples were annealed isothermally at 400 °C for 1 to 240 minutes to allow recrystallization. Recrystallization kinetics of the alloys is analyzed from the micro-hardness variation. Isothermally annealed samples of aluminum alloys were ...
متن کاملSilicon particle pinhole defects in aluminium–silicon alloys
It was recently shown that silicon particles in heat-treated Al–Si casting alloys can contain flaws such as surface pinholes and grooves, which cause varying degrees of reduction in the in situ particle fracture strength and hence influence the mechanical properties of this class of alloys. In this work, we show that the formation of one class of such strength-limiting flaws in solidified and c...
متن کاملRecovery by triple junction motion in aluminium deformed to ultrahigh strains
Commercial purity aluminium at true strains 3 = 2∼ 5.5 was annealed in a wide temperature range (from room temperature to 220◦C), and the evolution of microstructure was characterized using transmission electron microscopy (TEM) and electron backscattered diffraction (EBSD) techniques. Triple junctions in an ultrafine lamellar structure are classified into three categories based on the structur...
متن کامل